CAUTION
If burner does not light, turn knobs to OFF , wait 5 minutes, and try again. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
Match-Lighting
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP tank.
2.Place lit match into match lighting stick, then into lighting hole on right side of grill.
3.Push in and turn far right burner knob to HI. Be sure burner lights and stays lit.
4.Light adjacent burners in sequence by pushing knobs in and turning to HI.
Ignitor Lighting The Sideburner
Do not lean over grill while lighting.
1.To ignite sideburner, open sideburner cover.
2.Turn sideburner knob to HI, push and hold ELECTRONIC IGNITOR button.
3.If sideburner does NOT light, turn knob to OFF, wait 5 minutes, then repeat lighting procedure or use match.
Match Lighting
1.To match light sideburner, open sideburner cover.
2.Place lit match near burner.
3.Push in and turn sideburner knob counterclockwise.
Be sure burner lights and stays lit.
Burner Flame Check
•Remove cooking grates. Light burner, rotate knobs from HI to LOW. You should see a smaller flame in LO position than seen on HI. Always check flame prior to each use. Perform flame check on sideburner. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.
HI
LO
Turning Grill Off
•Turn all knobs to OFF position. Turn LP tank off by turning
Ignitor Check
•Turn gas off at LP tank. Press and hold electronic ignitor button. "Click" should be heard and spark seen each time between collector box or burner and electrodes. See "Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is off at LP tank before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LO position then turn back to OFF position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn. Replace damaged hoses before using grill. Use only valve/hose/regulator specified by manufacturer.
General Grill Cleaning
•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.
•Plastic parts: Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.
•Porcelain surfaces: Because of
•Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy water. Wipe dry with a soft nonabrasive cloth.
•Stainless steel surfaces: To maintain your grill’s high quality appearance, wash with mild detergent and warm soapy water and wipe dry with a soft cloth after each use.
20 • 463240804