Char-Broil 463270309 manual Problem Possible Cause Prevention/Solution

Page 28

Troubleshooting (continued)

Problem

Possible Cause

Prevention/Solution

 

 

 

Burner(s) will not light

•Faulty electronic ignition circuit.

•See Troubleshooting Integrated Electronic Ignition section.

using ignitor.

•Sparking somewhere other than

•Inspect wire insulation and proper connections. Replace wires if

 

 

between burner and electrode.

insulation is broken.

 

 

 

Burner(s) will not

•See “GAS ISSUES:” on previous page.

 

match light.

•Improper method of match-lighting.

•See “Match-Lighting” section of Use and Care.

 

 

 

 

Sudden drop in gas

•Out of gas.

•Check for gas in LP tank.

flow or low flame.

•Excess flow valve tripped.

•Turn off knobs, wait 30 seconds and light grill. If flames are still low,

 

 

 

turn off knobs and LP tank valve. Disconnect regulator. Reconnect

 

 

regulator and leak-test. Turn on LP tank valve, wait 30 seconds and

 

 

then light grill.

 

•Vapor lock at coupling nut/LP tank

•Turn off knobs and LP tank valve. Disconnect coupling nut from

 

connection.

tank. Reconnect and retry.

 

 

 

Flames blow out.

•High or gusting winds.

•Turn front of grill to face wind or increase flame height.

 

•Low on LP gas.

•Refill LP tank.

 

•Excess flow valve tripped.

•Refer to “Sudden drop in gas flow” above.

 

 

 

Flare-up.

•Grease buildup.

•Clean burners and inside of grill/firebox.

 

•Excessive fat in meat.

•Trim fat from meat before grilling.

 

•Excessive cooking temperature.

•Adjust (lower) temperature accordingly.

 

 

 

Persistent grease fire.

•Grease trapped by food buildup around

•Turn knobs to OFF. Turn gas off at LP tank. Leave lid in position and

 

burner system.

let fire burn out. After grill cools, remove and clean all parts.

 

 

 

Flashback...

•Burner and/or burner tubes are blocked.

•Turn knobs to OFF. Clean burner and/or burner tubes. See burner

(fire in burner tube(s)).

 

cleaning section of Use and Care manual.

 

 

 

Unable to fill LP tank.

•Some dealers have older fill nozzles

•The worn nozzles don’t have enough “bite” to engage the valve. Try

 

with worn threads.

a second LP dealer.

 

 

 

One burner does not

•Grease buildup or food particles in

•Clean carry-over tube(s) with wire brush.

light from other

end(s) of carryover tube(s).

 

burner(s).

 

 

 

 

 

 

28

Image 28
Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling Connecting Regulator to the LP Cylinder For your safetyUseDo not household cleaning agents. Damage to gas LP Cylinder ExchangeConnection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF For Safe Use of Your Grill and to Avoid Serious Injury Main Burner Ignitor LightingGeneral Grill Cleaning Sideburner Ignitor LightingSideburner Match Lighting Burner Flame CheckCleaning the Burner Assembly Storing Your GrillTurn gas OFF at control knobs and LP cylinder BurnerTemperature Grilling Guide Getting StartedFirst Time Use Lava Rock / BriquettesFood Safety Grilling Guide GrillingDirect Cooking Indirect CookingUsda Recommended Safe Minimum Internal Temperatures Grilling Guide Tips & TricksGrilling Guide Cleaning Your Grill Limited Warranty All Parts Year from date of purchaseParts List Key Qty DescriptionParts Diagram Assembly FrontGrill head Regulator hose Upper back panel Now you may fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracket Electrode Sideburner grate Sideburner Ignitor Wire Rear Heat shield Nut Cap Cylinder screw at rear of cart Grease tray Troubleshooting Emergencies Possible Cause Prevention/SolutionProblem Possible Cause Prevention/Solution Troubleshooting Integrated Electronic Ignition SectionPage Regtemp REV00