Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International BELGIUM. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change
Fax +32 2 359 95 50 the page numbering. Keep the language integrity. Print only what is inside the frame.
BEFORE FIRST USE
•Before using the grill for the first time, it’s a good idea to assemble it fully indoors, to check that you’ve got all the parts and that they’re all in the right places.
•Clean the grill and all the accessories (Cf. "Cleaning and care"). It is recommended to heat up the grill for about 10 minutes without any foodstuff in order to eliminate the grease that may have adhered during manufacture and the "new" smell.
•Ventilate the room during this period or use outside.
ASSEMBLY
•Align the power inlet on the grill plate with the recess in the side of the grill housing, and lower the grill plate into the top of the grill housing.
•The feet underneath the grill plate will rest on 4 specially strengthened points inside the grill housing.
•The tab in the middle of the recess will go through the slot underneath the power inlet, and push up the cover inside the power inlet to expose the earth socket inside the power inlet.
•The earth contact protruding from the temperature control fits through the hole in the tab, and into this socket.
•If the grill plate is not properly fitted in the grill housing, you will not be able to fit the temperature control to the grill, and the grill will not function. This is a safety feature. Do not try to overcome it.
•Do not try to use the grill plate on its own. It must only be used with the grill housing.
•Push the drip tray into the gap on the front of the grill housing.
•Check that it is placed under the holes in the grill plate.
•If you’re not using the stand, sit the grill housing on a stable, level, heat- resistant surface.
NOTE: If you’re not using the stand, miss out the next assembly points
•Use the screws supplied to attach the 3 stabilizers to the bottom of the stand.
•The stabilizers fit into the gaps between the legs of the stand to form a circle at the base
•Put the stand on a stable, level surface.
•To fit the mp3 holster, push the narrow end of the tube through the hole in the removable holster.
•Fit the narrow end of the tube into the hole in the top of the stand, so that it engages with the screw inside the stand, and then turn the tube clockwise to tighten it.
•Don’t
6 | GRB 32231 - 111026 |