Lighting Instructions

Read entire instructions before lighting.

Follow the instructions each time you light your Fire Magic Barbecue or Backburner.

FOR AUTOMATIC LIGHTING:

FOR MANUAL LIGHTING:

1.Open the lid.

2.Turn all three Barbecue valve to the “OFF” position.

3.Turn on the gas at the source outside of the Barbecue enclosure.

4.Remove the Backburner cover if you are lighting the Backburner.

gas valves and the Backburner

OFF MARKER

				O	N				TO
					N				TU
			N						TU
	TU	R	N						RN
		R							RN
TO									O
						P			FF
					OFF	U			FF
					OFF	S
						T	H
						U		T
						R
							N O
									HI LIGHT

CAUTION: Always wait 5 minutes for gas to clear after any unsuccessful lighting attempt.

1.Follow steps 1 through 4 of "Automatic Lighting" section

2.Insert either a burning long-barrel butane lighter, a burning long-stem match or a burning match held by the match holder (attached to the drip tray) (Figure 9) through the

Figure 9 - Match Holder

NOTE: DO NOT turn on		HIGH TO
		LIGHT
		MED
more than one valve at a		MED
more than one valve at a
time for either		Figure 8 - Valve Control Knob
automatic or manual		Figure 8 - Valve Control Knob
lighting.	Adjacent

Barbecue Burners will cross-ignite.

5.Depress either the center gas valve knob or the Backburner knob and turn to “HIGH” then immediately press the Spark Generator button (see Figure 10). The Burners should light.

CAUTION: If the Burners do not light within 5 seconds depress the knob and turn the valve to “OFF”. WAIT 5 MINUTES before repeating step 5 If the Burners still do not light after several attempts, refer to the instructions for manual lighting.

Cooking Grids to the Burners below the Flavor Grid (Figure 10). For Backburners, hold the flame against the perforated material near the Backburner.

3.While holding the match or lighter flame next to the Burner, depress the appropriate Valve knob and turn it counterclockwise to the “HIGH” position. The Burner should light.

4.If Burner does not light, IMMEDIATELY DEPRESS the knob and turn valve to “OFF”. WAIT 5 MINUTES before repeating steps 2 through 4 of Manual lighting instructions.

NOTE: Barbecues in some installations achieve a better air/ gas mixture and will ignite quicker if the valve is first turned beyond High to Medium or Low for lighting.

IF YOU SMELL GAS

1.Shut off gas to the appliance.

2.Extinguish any open flame.

3.Open lid.

4.If the odor continues, immediately call your gas supplier or fire department.

REMEMBER: FOR SAFE MANUAL LIGHTING, PLACE A BURNING MATCH OR BUTANE LIGHTER BESIDE THE BURNER - THEN TURN ON THE GAS (Figure 10).

Backburner Valve

Figure 10 - Knob Positions

&Backburner Ignitor

Manual LightingButton