Summit 21287 manual Tank Cabinet Troubleshooting, Problem Check Cure

GAS INSTRUCTIONS

Liquid Propane (LP) Cylinder(s)

•The joint where the hose connects to the LP cylinder must be leak tested each time the LP cylinder is reconnected. For example, test each time the LP cylinder is refi lled.

•Be sure the regulator is mounted with the small vent hole pointed downward so that it will not collect water. This vent should be free of dirt, grease, bugs etc.

•The LP cylinder and connections supplied with your Weber® gas barbecue have been designed and tested to

meet government, American Gas Association, and Under- writers Laboratories requirements.

If you have questions about spare LP cylinders contact Customer Service at 1(800) 446-1071.

•All LP tank supply systems must include a collar to pro- tect the cylinder valve.

•The LP cylinder must be a 20-lb. size (18 1/4 inches high, 12 1/4 inches in diameter).

•The cylinder should be constructed and marked in ac- cordance with the Specifi cations for LP - Gas Cylinders of the U.S. Department of Transportation (D.O.T.) or the National Standard of Canada, CAN/CSA-B339, Cylin- ders, Spheres and Tubes or Transportation of Dangerous Goods; and Commission, as applicable.

(1)

DOT 4BA240

00/02

(2)

TANK CABINET TROUBLESHOOTING

Problem	Check	Cure
Burner does not light	Is gas supply off?	Turn supply on
Flame is low in HIGH position.	Is fuel hose bent or kinked?	Straighten fuel hose.
Burners do not light. -or- Burners	The excess fl ow safety device,	To reset the excess flow safety
have a small flickering flame in	which is part of the barbecue to	device turn all burner control
the HIGH position. -or-	cylinder connection, may have	knobs and the cylinder valve OFF.
Barbecue temperature only	activated.	Disconnect the regulator from the
reaches 250˚ to 300˚ in the HIGH		cylinder. Turn burner control knobs
position.		to HIGH. Wait at least 1 minute.
		Turn burner control knobs OFF.
		Reconnect the regulator to the
		cylinder. Turn cylinder valve on slowly.
		Refer to “Lighting Instructions”.

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your region using the contact information sheet provided with your manual.

12