Check for GAS Leaks, Customer Service

GAS INSTRUCTIONS

CHECK FOR GAS LEAKS

After a period of nonuse, we recommend that you perform the following maintenance procedures for your safety.

WARNING: Check the hose before each use of the grill for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the grill. Replace using only Summit® authorized replacement hose. Contact the Summit® Built-In Customer Service at 1-800-446-1071.

•Inspect the burners for correct ﬂ ame pattern. Clean if necessary, following the procedures outlined in the “General Maintenance” section of this manual.

•Check all gas ﬁ ttings for leaks.

DANGER

Do not use an open ﬂame to check for gas leaks. Be sure there are no sparks or open ﬂames in the area while you check for leaks. Sparks or open ﬂames will result in a ﬁre or explosion, which can cause serious bodily injury or death and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas ﬁtting.

Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been ﬂ ame-tested. As a safety precaution however, you should recheck all

ﬁttings for leaks before using your Weber Gas Barbecue. Shipping and handling may loosen or damage a gas ﬁ tting.

WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution, and a rag or brush to apply it.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

Make sure side burner is OFF.

To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise.

WARNING: Do not ignite burners when leak checking. Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if

a bubble grows, there is a leak. Check:

1)Gas Line-to-”T” Connection

2)Regulator-to-Cylinder connection.

WARNING: If there is a leak at connection (1), retighten the ﬁtting with a wrench and recheck for leaks with soap and water solution.

If a leak persists after re-tightening the ﬁtting, turn OFF the gas. DO NOT OPERATE THE GRILL. Contact

Customer Service 1-800-446-1071.

Check:

3)“T” Connection-to-Hose connections.

4)The hose-to-Regulator connection.

WARNING: If there is a leak at connections (2,3, or 4), turn OFF the gas. DO NOT OPERATE THE GRILL.

Contact Customer Service 1-800-446-1071.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

(1)

Side View

(2)

Side View

(3)

(4)