WOL F GRI LL MODULE
ELEC TRIC AL REQU IREMENTS
Attach the power cord to the unit before plugging the cord into the wall.
Required Power Supply
Maximum Connected Load
2.8 kW
The Wolf electric grill module requires 15 amp service with its own circuit breaker or fuse. Locate electrical within the shaded area shown in the illustration on page 7.A properly rated cord should be attached to the power supply box of the grill as shown in the illustration below. Open the power box to expose the screws with corresponding numbers. Loosen the 1, 5, and ground screws. Run the cord through the circular hole and into the power supply box. Attach the Neutral wire to the number 1 position. Attach the line wire to the 5 position and attach the ground wire to the corresponding ground screw. After tightening the screws, close the cover to the power supply box without pinching any of the wires.
You must follow all local codes and ordinances when installing your service.
IMPORTANT NOTE: The correct voltage, frequency and amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly sized circuit breaker or time delay fuse. The proper voltage, frequency, and amperage ratings are listed on the product rating plate located on the underside of the module. Refer to the illus- tration on page 5. The wiring diagram covering the control circuit is located inside the module control box.
The complete appliance must be properly grounded at all times when electrical power is applied.
Improper connection can result in a fire hazard!
IMPORTANT NOTE: To avoid electrical shock when disconnecting the grill module, all poles/wires must be disconnected from the power supply box.
Power supply box
9