GAS Cylinder Mounting Instructions

A-5	A-5

AC-225-C WELDER TO THE UTILITY CART

Parts Required:
Part Number	Description	Required
S8025-54	1/4-20 x 1.25	4
Screw

Refer to FIGURE 9 while mounting your AC-225-C welder.

Position the AC-225-C as shown. Attach the AC-225- C with four 1/4 x 1 1/4 in. Self-tapping screws from underneath using the holes provided in the base of the AC-225-C and the Utility Cart.

If desired, the chain and buckle/strap assemblies may be removed, since a gas bottle is not required when

CAUTION

welding with an AC-225-C.

THE HANDLE ON YOUR AC-225-C IS NOT TO BE USED FOR LIFTING WHEN THE AC-225C IS ATTACHED TO THE UTILITY CART. THE HANDLE IS FOR LIFTING THE AC-225-C ONLY! DO NOT LIFT BY THE HANDLE WHEN THE CART IS

ATTACHED.

------------------------------------------------------------------------

WARNING

CYLINDER could explode if damaged.

• Keep cylinder upright and chained to a support.

•Keep cylinder away from areas where it could be damaged.

•Never lift welder with cylinder attached.

•Never allow the welding electrode to touch the cylinder.

•Keep cylinder away from welding and other live

electrical circuits.

___________________________________________

GAS CYLINDERS LESS THAN 15 INCHES (40CM) TALL

Set the cylinder upright on the rear of the Bottom Shelf. Secure in place with the Strap and Buckle Assembly. The cylinder must be held tightly against theTank Support. The chain is not used.

GAS CYLINDERS GREATER THAN 15 INCHES (40CM) TALL

Set the cylinder upright on the rear of the Bottom Shelf. Secure in place by looping the Chain around the bottle, and passing the end of the chain through the keyhole slot in the Top Shelf. Lock the link that gives the tightest fit around the bottle in the narrow slot. Secure the lower portion of the bottle with the strap and Buckel Assembly. Both the Chain and the Strap Assembly must be used.

FIGURE 9