Lincoln Electric IM468-A manual Front casters are installed at the factory

Page 9

A-3

A-3

 

 

STEP 8

Tighten all eleven screws (7 inserted by the customer, 4 inserted at the factory) used to hold the Utility Cart together.

STEP 9 (SEE FIGURE 6)

Stand the Utility Cart on its front. Slide the Rear Axle through the mounting holes provided. Place the inside washers, then the Wheels, then the outside washers. Secure the wheels in place with cotter keys in the holes provided and bend the ends to secure them in place. Place the Utility Cart in the upright position.

FIGURE 6

STEP 10

The front casters are installed at the factory.

STEP 11 (SEE FIGURE 7)

Insert the Handle as shown. Slide it into the Front Upright, adjusting it to a comfortable position. Secure the handle using the two 1/4-20 x 1.50 screws by aligning the hole in the end of the handle with one set of holes in the Front Upright, and sliding the screws through the holes. Secure the screws with one lock- washer and one nut on each screw.

FIGURE 7

The Utility Cart is now fully assembled. Refer to the following instructions for mounting your specific welder to the Utility Cart.

Image 9
Contents K520 Utility Cart Safety Electric Shock can kill Cylinder may explode if damaged Sûreté Pour Soudage a L’Arc Précautions DE SûretéThank You Specifications Cart Assembly InstructionsProduct Description See Figure Front casters are installed at the factory Welder Mounting Instructions AC-225-C Welder to the Utility Cart GAS Cylinder Mounting InstructionsProducts Supported Operating InstructionsDimension Print Precaucion Warnung