Chapter 4: Configuration and Setup
4.2Routing the Cable (UCCDS20T, UCCDS20H, UCCDS30T, UCCDS30H, UCCDS40T, UCCDS40H)
1.At the back of the cart, loosen the two screws on the cable manager, pull up on the top section of the cable manager, and place the device side of the charging cable into one of the slots. (See Figure
Loosen screws on cable manager
Cable manager 
and pull up
Route cable to the
front of the cart
Power
Strip
Wrap excess cable | Charger |
around cable wrap |
|
Figure 4-2. Small shelf routing instructions.
2.Replace the top section of the cable manager and tighten the screws.
3.Route the device side of the charging cable to the front of the cart and repeat step 1 for the front cable manager.
4.Wrap any excess cable around the cable wrap on the back of the shelf.
5.Plug the charger power plug into the power strip located below the shelf.
| Page 15 |