offset
clip
Step 6
Reinstall the E-Units (set aside from being removed from the rear) as follows:
1.Rotate the E-Unit 180 degrees (from original position).
2.Position to the front of cart.
3.Tilt in and set against offset of bottom panel (of cart).
4.Grip the top and tilt to the upright position.
When repositioned correctly, the E-Unit power switch should face the front.
Reinstall the E-Unit bracket assemblies (make sure that the top flange of the E-unit is aligned with the slot in the bracket assembly) and tighten screws securely.
From underneath the bottom shelf, feed the E-Unit power cords (plug end) all the way through the bottom rear round grommeted cutouts (next to bracket assembly).
Press each E-Unit power cord into the two wire clips located (in line, behind E-Unit) on the bottom of cart. Wind power cords around the cord wrap bracket on the rear panel for storage.
Installation is now complete and ready for use.
