Bretford LAP24EBA manual Timer Installation E-UNIT AT Front Location

Page 25

NOTE:

UNPLUG CART POWER CORDS FROM POWER SOURCE BEFORE STARTING

TIMER INSTALLATION: 'E-UNIT AT FRONT LOCATION'

SEE DETAIL 'B'

Please read and follow all instructions thoroughly. Bretford will not be held responsible for improper installation or misuse of the timer unit.

bottom shelf

SEE DETAIL 'A'

Step 1

Open both front doors of cart to access E-Units. Unwind any length of E-Unit power cord remaining on the back panel cord wrap brackets. Unclip the power cords from the side panel clips (see DETAIL 'A'). Loosen the screw holding the E-Unit bracket assembly and remove all 4 bracket assemblies (see DETAILS 'A' and 'B').

clip

bracket assembly

bracket assembly

DETAIL 'B'

DETAIL 'A'

Image 25
Contents Unit Repositioning Front to Rear LAP24EBA LAP24EFRDetail B Detail C Detail D Cutout window Clip-rear Detail E Unit Repositioning Rear to Front Front View Rear-left Rear-right Detail F Offset Clip Unit Replacement Rear Location Front View Detail D Cutout window Clip-rear Round cutout Detail E Unit Replacement Front Location Bracket assembly Clip Offset Front-left Clip Front-right Bottom shelf Timer Installation E-UNIT AT Rear Location Step Filler bracket Bracket Unit cord Timer cord Bottom flange Timer/bracket See Detail C. do not Over Tighten Screws Timer Installation E-UNIT AT Front Location Front-left Front-right Detail B Bottom flange- timer/bracket Step Detail C Bottom shelf Offset Front-left Front-right Clip Label Installation Be Sure to Record Your Combination PAD Lock Door