SAFETY INFORMATION
1.Check the heater completely and thoroughly for damage. DO NOT run a damaged heater.
2.DO NOT alter the heater or operate a heater that has been modified from its original condition.
3.Use only propane gas.
4.Use only vapor withdrawal propane gas. If any question, contact your LP dealer.
5.Do not use this heater as a
6.Inspect hose assembly before each use of the heater. If there is excessive abrasion or hose is cut, STOP USING HEATER! Replace with a new hose.
7.This heater is for outdoor use only. Even so make sure that there is ample fresh air ventilation. Do not use in buildings, garages or other enclosed spaces.
8.In the event that gas odor is detected, IMMEDIATELY STOP operation until gas supply has been located and corrected.
9.Do not place the heater where directly exposed to water spray, rain, dripping water or wind.
10.Maintain minimum clearance to people or normal combustible material (like paper) of 2 feet.
11.Place heater on a stable, level surface.
12.You must operate the heater with the heater screen in place. Make sure heater screen is in place before running heater.
13.This heater is designed to be smokeless. If logs ever appear to smoke, turn off heater and call a qualified service person. Note: during initial operation, slight smoking could occur due to log curing and heater burning manufacturing residues.
14.Do not attempt to move, handle or service while heater is hot or in operation.
15.Use only in accordance with local codes or, in the absence of local codes, with the National Fuel Gas Code
16.Do not hang or attach clothing or any other flammable materials on or near the heater.
17.Carefully supervise young children when they are in the vicinity of heater.
18.Heater becomes very hot while running. Keep children and adults away from hot surface to avoid burns or clothing ignition.
19.Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that control compartment, burners and circulating air passageways of the appliance be kept clean.
PRODUCT IDENTIFICATION
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code, ANSZ223.1, also known as NFPA54*.
Available from :
American National Standards Institute, INC.
1430 Broadway, New York, NY10018 National Fire Protection Association, INC. Batterymarch Park Quincy. MA 02269
UNPACKING
1.Remove top inner pack.
2.Slide stove out of carton and set it on the flat floor.
3.Remove protective packaging.(See FIG.2)
4.Remove plastic wrap and carton from MID base.
5.Turn the door knob clockwise, open heater door to take out log set, Remove all protective plastic wrap.
6.Unwrap log set by cutting plastic ties.
7.Check for any shipping damage. If stove or log is damaged, promptly inform dealer where you bought the stove.
Figure 2- shipping fireplace
2 |