Lighting Instructions

OPEN LID.

ENSURING BURNER CONTROLS

ARE IN THE OFF POSITION, TURN

ON THE GAS SUPPLY VALVE.

LEFT BURNER CENTER BURNER SIDE BURNER RIGHT BURNER

MAIN BURNER LIGHTING

1.PUSH AND TURN ANY MAIN BURNER KNOB SLOWLY TO

THE ’HI’ POSTION. THISACTION WILL IGNITE THE PILOT FLAME WHICH WILL IN TURN LIGHT THE SELECTED BURNER. IF THE PILOT LIGHTS, CONTINUE TO PUSH DOWN ON THE CONTROL KNOB UNTIL THE BURNER LIGHTS AND THEN RELEASE.

2.IF THE PILOT DOES NOT IGNITE, THEN IMMEDIATELY TURN THE CONTROL KNOB

BACK TO THE ‘OFF POSITION AND REPEAT STEP 1 SEVERAL TIMES.

3.IF THE PILOT AND BURNER WILL NOT IGNITE WITHIN 5 SECONDS,

TURN THE CONTROL KNOB TO THE

‘OFF’ POSITION AND WAIT 5

MINUTES FOR ANY EXCESS GAS TO DISSIPATE. EITHER REPEAT STEPS 1 AND 2 OR LIGHT WITH A MATCH.

SIDE BURNER LIGHTING

1.OPEN SIDE BURNER COVER.

2.PUSH AND TURN THE SIDE BURNER CONTROL

KNOB SLOWLY TO THE

‘HI’ POSITION. THIS ACTION WILL IGNITE THE SIDE BURNER

3.IF THE BURNER DOES NOT IGNITE, THEN IMMEDIATELY TURN THE CONTROL KNOB

BACK TO THE ‘OFF’ POSITION AND REPEAT STEP 2 SEVERAL TIMES.

4.IF THE BURNER WILL NOT IGNITE WITHIN 5 SECONDS, TURN THE CONTROL KNOB TO THE ‘OFF’ POSITION AND WAIT 5 MINUTES

FOR ANY EXCESS GAS TO

DISSIPATE. EITHER REPEAT STEPS 2 AND 3 OR LIGHT WITH A MATCH.

The propane cylinder is equipped with an excess flow device. Unless all burners are turned off prior to turning the cylinder on, only small flames will be achievable.

If lighting the unit with a match, clip the match into the supplied lighting rod. Hold the lit match down through the grill and sear plate while turning the corresponding burner

valve to high.