Desa (V)KC36NE Series, (V)KC36PE Series installation manual Checking GAS Connections

Page 23

Fireplace

Installation

Continued

 

 

Red Surface

Equipment

Flexible

Indicates For

Gas Line

Propane/LP Use

Shutoff

Do NOT

Only

 

Valve

Kink

 

 

 

 

 

1/2" NPT

Inlet

 

Outlet

Incoming

Pressure

Gas Line

Tap

 

Pressure

 

 

 

Tap

Note: Wire Connections Not Shown for Clarity

Figure 32 - Connecting Flexible Gas Line

to Electronic Valve

CHECKING GAS CONNECTIONS

WARNING: Test all gas piping and connections , internal and external to unit, for leaks after installing or servicing. Correct all leaks at once.

4.Check all joints of gas supply piping system. Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks at once.

5.Reconnect fireplace and equipment shutoff valve to gas supply. Check reconnected fittings for leaks.

Test Pressures Equal To or Less Than

1/2 PSIG (3.5 kPa)

1. Close equipment shutoff valve (see Figure 33).

2. Pressurize supply piping system by either opening propane/LP supply tank valve for propane/LP gas fireplace or opening main gas valve located on or near gas meter for natural gas fireplace or using compressed air.

3. Check all joints from propane/LP supply tank or gas meter to equipment shutoff valve (see Figure 34 or Figure 35). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks at once.

Equipment

Open

Shutoff Valve

 

Closed

Figure 33 - Equipment Shutoff Valve

WARNING:Neveruseanopen flame to check for a leak. Apply noncorrosive leak detection fluid toalljoints.Bubblesformingshow a leak. Correct all leaks at once.

Pressure Testing Gas Supply Piping System

Test Pressures In Excess Of 1/2 PSIG

(3.5 kPa)

1. Disconnect fireplace and its individual equip-

Propane/LP Supply Tank

Equipment Shutoff Valve

Gas Valve

ment shutoff valve from gas supply piping system. Pressures in excess of 1/2 psig (3.5 kPa) will damage fireplace gas regulator.

2. Cap off open end of gas pipe where equipment shutoff valve was connected.

3. Pressurize supply piping system by either opening propane/LP supply tank valve for propane/LP gas fireplace or opening main gas valve located on or near gas meter for natural gas fireplace or using compressed air.

Figure 34 - Checking Gas Joints for

Propane/LP Gas Fireplace

Equipment

Shutoff Valve

Gas

Meter

Gas Valve

Figure 35 - Checking Gas Joints for

Natural Gas Fireplace

116238-01E

www.desatech.com

23

Image 23
Contents Patent Pending What to do if YOU Smell GASSafety Information Table of ContentsSafety information High traffic areas Product IdentificationLocal Codes Location and space requirements Product FeaturesPre-Installation Preparation For specific venting ClearancesFraming and finishing Front Top of Standoffs VentClearances for Combustible Mantels Balcony with Perpendicular Side Wall Location of Termination CapInstallation Precautions Venting Installation InstructionsInstallation Planning Installing Horizontal Vent Cap Noncombustible Exterior Round Termination Square TerminationRecommended Applications Corner ground floor installation Corner InstallationHorizontal System Installation Using TWO 90 Elbows Connect a section of pipe and extend up through the hole Installation for vertical terminationFlat Ceiling Installation Twist-lock the vent cap onto the last section of vent pipe Vertical Venting High Altitude InstallationDesa 5/8 Pipe & Vent Kits Number Description Parts list for venting kits and componentsPlug in blower power cord Fireplace InstallationInstalling optional blower accessories Model BK InstallationBlower Model BKT Model BKT InstallationInstallation Items Needed Installing Gas Piping to Fireplace LocationBlower Wiring Diagram Propane/LP Supply TankExternal Regulator Vent Pointing Down Connecting Fireplace to GAS SupplyDisconnect fireplace and its individual equip Checking GAS ConnectionsTest Pressures Equal To or Less Than Psig 3.5 kPa Close equipment shutoff valve see FigureRemoving Glass Door Pressure Testing Fireplace Gas ConnectionsRemoving Louver Panels Cleaning Glass Door Installing lava rock and glowing embersInstalling Brick liner Models BL36DASA and BL36DHASA Replace screen/rod assembly by reversing stepReplace top and bottom louvers Wall Switch InstallationOptional Remote control Installation model WRC Pilot Wiring DiagramTo Turn OFF GAS To Appliance For your safety Read before lightingOperating Fireplace Lighting InstructionsOptional Remote Operation Operating optional blower accessoryPilot Assembly Inspecting BurnersLogs Cleaning MaintenanceGlass Door Pilot and burnersVenting system TroubleshootingObserved Problem Possible Cause Remedy Low, causing safety pilot to Check wiring connectionUle And/or check ground wire to No gas to burner, although wall Wall switch wires defectiveGas leak. See Warning Statement at topSpecifications Replacement PartsService Hints Technical ServiceAccessories Models KC36NE, VKC36NE, KC36PE and VKC36PE series Illustrated Parts BreakdownParts List 19 18 31 33 116238-01E Firebox Bottom Limited Warranty DIRECT-VENT Fireplace Warranty InformationKeep this Warranty