Desa (V)VC42NE Series, (V)VC42PE Series installation manual Wiring Diagram, Operating Fireplace

WIRING DIAGRAM

OPERATING FIREPLACE

For Your Safety Read Before Lighting Lighting Instructions

23

WIRING DIAGRAM

PILOT

IGNITOR LEAD

ORANGE

LIGHTING

INSTRUCTIONS

NOTICE: During initial operation of new heater, burn- ing logs will give off a paper-burning smell. Orange flame will also be present. Open damper or window to vent smell. This will only last a few hours.

			BLUE		1.	STOP! Read the safety information, column 1.
	E12	SYNETEK CONTROLS IS1070B	TRANSFORMER		2.	Turn off all electric power to the appliance.
			WHITE		3.	Turn wall switch to the OFF position.
EV1	E8		24V AC	120V AC
	E6				4.	Open lower louver panel.
	E4							to the OFF
					5.	Turn equipment shutoff valve clockwise
	E3
	E2
		INC	BLACK			position (see Figure 42). Do not force.
			GROUND		6.	Wait five (5) minutes to clear out any gas. Then smell for
EV2			RED
						gas, including near the floor. If you smell gas, STOP! Fol-
	GREEN
						low “B” in the safety information in column 1. If you donʼt
						smell gas, go to the next step.			to
					7.	Turn equipment shutoff valve counterclockwise
OPERATING FIREPLACE						the ON position. Do not force.
					8.	Close lower louver panel.
					9.	Turn on all electric power to the appliance.
	FOR YOUR SAFETY
					10.	Turn the wall switch to the ON position.
	READ BEFORE LIGHTING
					11.	Visually locate the pilot. The ignitor should begin to spark and
WARNING: If you do not follow these instructions						the main burner should ignite once flame appears at pilot.
						•	If lighting the appliance for the first time each season,
exactly, a fire or explosion may result causing property
							it may take several attempts before the supply gas can
damage, personal injury or loss of life.
							reach the pilot and main burners.
						•
A. This appliance is equipped with an ignition device which							If the appliance will not stay lit after several attempts,
							follow the instructions To Turn Off Gas To Appliance,		on
automatically lights the pilot. Do not try to light the pilot
							page 24, and call your service technician or gas supplier.
by hand.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch.

•Do not use any phone in your building.

•Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.

•If you cannot reach your gas supplier, call the fire department.

C.	Do not use this appliance if any part has been under water.
	Immediately call a qualified service technician to inspect
	the appliance and to replace any part of the control system
	and any gas control which has been under water.

Equipment	Pilot
	Adjustment
Shutoff
	Screw
Valve

Figure 42 - Turning Equipment Shutoff Valve to the OFF Position

116237-01D www.desatech.com