4
PRODUCT FEATURES UNPACKING ASSEMBLY
Assembling Fireplace
PRODUCT FEATURES
SAFETY PILOT
This fireplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent- free room fireplaces. The ODS/pilot shuts off the fireplace if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor. This system requires no matches, batteries, or other sources to light fireplace.
ASSEMBLY
WARNING: Always have branch support and screen in place before operating fireplace. This pre- vents excessive temperatures on fireplace surfaces.
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.
THERMOSTATIC HEAT CONTROL
This fireplace has a thermostat sensing bulb and a control valve. The thermostat will automatically modulate the heat output to maintain a consistent room temperature. This results in greater fireplace comfort. This can also result in lower gas bills.
UNPACKING
1.Remove log box and fireplace from carton. IMPORTANT: The fireplace hood is inside the cardboard protective end wrap on the left side of fireplace (as viewed from front). A decal is on the outside of the cardboard end wrap stating hood is enclosed (see Figure 2).
2.Remove hood from cardboard protective end wrap as shown in Figure 2.
3.Remove all protective packaging applied to fireplace for shipment.
4.Make sure your fireplace includes one hardware packet.
5.Check fireplace for any shipping damage. If fireplace is dam- aged, promptly inform dealer where you bought fireplace.
IMPORTANT:
THIS PACKAGE CONTAINS A
Hood Enclosed FIREPLACE HOOD. UNWRAP
Decal 
CARTON AND REMOVE HOOD
BEFORE DISCARDING
PROTECTIVE PACKAGING.
Cardboard Protective
Fireplace End Wrap
2
Hood
1 
ASSEMBLING FIREPLACE
Tools Required:
•Phillips screwdriver
•5/16" hex wrench
•slotted screwdriver
•scissors
Installing Log
1.Lift screen up and pull out to remove.
2.Cut two plastic straps to remove the log from the firebox cavity.
3.An optional blower is available. See Accessories, page 29. In- stall optional blower now. Follow installation instructions pro- vided with blower.
4.Remove log packaging material and discard packaging. Gently place log set on burner support (see Figure 3). The log should fit flat against top of burner support and log locator tabs fit into the slots under the log. Do not allow log to contact flame. If flame contacts log, soot will be created.
5.Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.
Log | Shoulder | Burner Support with |
| Screw | Log Locator Tabs |
Screen
Branch Support
Figure 2 - Removing Fireplace Hood | Figure 3 - Assembling Fireplace | |
| ||
For | . | .com |