OWNER’S MANUAL
INSTALLATION
Continued
ASSEMBLING BRASS TRIM (Brass trim shipped with mantel)
1.Remove packaging from three remain- ing pieces of brass trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 14.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 14).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 14).
6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other corner.
8.Set brass a7ssembly aside for later installation.
2.Fold floor anchor as shown in Figure 15.
3.Insert floor anchor (wings first) into hole. Tap anchor flush to floor.
4.Insert mounting screws through base and into floor anchors.
5.Tighten screws until base is firmly fas- tened to floor.
Figure 15 - Folding Anchor
CONNECTING TO GAS SUPPLY
WARNING: A qualified ser- vice person must connect fire- place to gas supply. Follow all local codes.
WARNING: Never connect fireplace to private
CAUTION: Use pipe joint seal- ant that is resistant to liquid pe- troleum (LP) gas.
Install sediment trap in supply line as shown in Figure 16. Locate sediment trap where it is within reach for cleaning. Locate sediment trap where trapped matter is not likely to freeze. A sediment trap traps moisture and contaminants. This keeps them from going into fireplace controls. If sediment trap is not installed or is installed wrong, fireplace may not run properly.
A.G.A.
Manual Shutoff Valve
With 1/8" NPT Tap*
| From Gas | |
Approved | Meter | |
(5" W.C. to | ||
Flexible Gas Line | ||
10.5" W.C. | ||
| ||
| Pressure) |
Set Screws
Slot
Top Brass Trim
known as wellhead gas.
IMPORTANT: Check gas line pressure before connecting fireplace to gas line. Gas line pressure must be no greater than 14
3" Minimum |
Pipe Nipple Cap Tee Joint |
| Shim | Mitered |
| Edge | |
|
| |
Adjusting |
| Side |
Plate |
| Brass |
| Slot | Trim |
|
|
Figure 14 - Assembling Brass Trim
ATTACHING WOOD BASE TO SOLID FLOOR
For attaching base to solid floors (concrete or masonry)
Note: Floor anchors and mounting screws are in hardware package. The hardware pack- age is provided with fireplace.
1.Drill holes at marked locations using 5/16" drill bit. For solid floors (concrete or masonry), drill at least 1" deep.
inches of water. If gas line pressure is higher, fireplace regulator damage could occur.
CAUTION: Use only new, black iron or steel pipe. Inter-
Installation must include a manual shutoff valve, union, and plugged 1/8" NPT tap. Locate NPT tap within reach for test gauge hook up. NPT tap must be upstream from fireplace (see Figure 16).
Apply pipe joint sealant lightly to male threads. This will prevent excess sealant from going into pipe. Excess sealant in pipe could result in clogged fireplace valves.
Sediment Trap |
Figure 16 - Gas Connection
*Purchase the optional A.G.A.
Continued
104277 | 11 |