Installing Logs

INSTALLATION

Checking Gas Connections (Cont.) Installing Logs

INSTALLATION

Continued

Equipment Shutoff Valve

Propane/LP

Supply Tank

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

Place one-piece log set on grate to fit as illustrated in Figure 27. Make sure back section of log set is seated into “U”-shaped cutout in center of chassis (see Figure 27). IMPORTANT: Make sure log does not cover any burner ports (see Figure 28).

One Piece Log Set

Figure 26 - Checking Gas Joints for Propane/LP Units (Shown with Optional Mantel)

Pressure Testing Fireplace Gas Connections

1.Open equipment shutoff valve (see Figure 24, page 14).

2.Open main gas valve located on or near gas meter for natural gas or open propane/LP supply tank valve.

3.Make sure control knob of fireplace is in the OFF position.

4.Check all joints from equipment shutoff valve to thermostat gas valve (see Figure 23, page 14). Apply noncorrosive leak detection fluid to gas joints. Bubbles forming show a leak.

5.Correct all leaks at once.

6.Light fireplace (see Operating Fireplace, pages 16 and 17). Check all other internal joints for leaks.

7.Turn off fireplace (see To Turn Off Gas to Appliance, page 16).

8.Replace front panel.

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.