OWNER’S MANUAL
INSTALLATION
Continued
Blower
Control
Shield
Switch
Plate
Screw
Figure 17 - Installing Switch Plate to Blower Control Shield
For Built-In Installation
WARNING: A licensed electri- cian must connect the wiring har- ness to electrical supply follow- ing all local codes. Electrician must provide a clamp on the box cover to secure the wiring. Wir- ing should be routed through the bushing in the hole on the outer casing of heater.
1.Install a snap bushing found in hard- ware kit into one of the holes found on rear of blower control shield. The other hole is for a strain relief clamp (not sup- plied) to secure incoming electrical supply.
2.Follow steps 2 through 6 in Installing Blower Assembly, page 10. Also re- move black wire from middle/OFF switch terminal.
3.Remove black plastic strain relief and power cord from switch plate (see Fig- ure 18). The power cord supplied will not be used in
4.A licensed electrician must follow the wiring diagram in Figure 19 to connect incoming electrical supply to fan kit wiring harness.
5.Test to make sure the blower is work- ing properly.
6.Reinstall hood assembly (see page 9) and close lower louver door.
7.Place log set back on the unit.
Blower Bracket
Assembly
Screw
Switch
Strain Wire
Relief Harness
| Power | |
| Cord | |
| Blue Red | |
Switch | Outlet | |
Receptacle | ||
Plate | ||
| ||
| Shield | |
| Cover | |
| Blower | |
| Control | |
| Shield |
Wire
Clamp Connector Harness (not included)
Figure 18 - Installing Blower Bracket Assembly
|
| Fan Switch |
| |||
|
| (Auto/Off/On) |
| |||
1 |
| Auto | Thermostat | |||
|
| Off 2 |
|
| Blue | |
|
| 3 | Switch | |||
|
|
|
| (N.O.) | ||
|
|
|
|
|
| |
|
|
|
|
|
| |
110/115 | On | Blue Blower | ||||
|
|
| ||||
| V.A.C. |
|
|
| Motor | |
|
| Black | Red | Red | ||
|
| |||||
|
| Green |
|
|
| White |
|
| White |
|
|
| |
|
|
|
|
|
| Green |
Figure 19 - Wiring Diagram For Fan Accessory
Built-In Installation
Continued
107187 | 11 | For more information, visit www.desatech.com |