Gas leak. See Warning statement at | Desa EVGL850N instruction

® EVGL850N

VENTED TYPE DECORATIVE APPLIANCE

TROUBLESHOOTING

Continued

WARNING: If you smell gas

•Shut off gas supply.

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating fireplace where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors.

OBSERVED PROBLEM

POSSIBLE CAUSE

REMEDY

Fireplace produces a clicking/ticking noise just after burner is lit or shut off

1.Metal expanding while heating or con- tracting while cooling

1.This is common with most fireplaces. If noise is excessive, contact qualified ser- vice person

Fireplace produces unwanted odors	1.	Fireplace burning vapors from paint, hair
		spray, glues, etc. (See IMPORTANT
		statement above)
	2.	Gas leak. See Warning statement at
		top of page

1.Ventilate room. Stop using odor caus- ing products while fireplace is running

2.Locate and correct all leaks (see Gas Line Hook-Up, page 9)

	1.	Gas leak. See Warning statement at	1.	Locate and correct all leaks (see Gas
Gas odor even when control knob is in OFF		top of page		Line Hook-Up, page 9)
position	2.	Control valve defective	2.	Replace control valve

1. Foreign matter between control valve

Gas odor during combustionand burner

2. Gas leak. See Warning statement at top of page

1.Take apart gas tubing and remove for- eign matter

2.Locate and correct all leaks (see Gas Line Hook-Up, page 9)

	1.	Improper log placement	1.	Properly locate logs (see Log & Ember
Dark residue on logs or inside of fireplace	2.	Air holes at burner inlet blocked		Placement, page 10)
			2.	Clean out air holes at burner inlets. Pe-
	3.	Burner flame holes blocked		riodically repeat as needed
			3.	Remove blockage or replace burner

www.desatech.com

107050