12
INSTALLING
Continued
INSTALLING BLOWER ACCESSORY (Model FB32C only)
You may install blower accessory GA3500A with conventional installation (page
15)or with
Conventional Installation of Blower Accessory
1. Install blower assembly per instruction sheet included in blower accessory kit.
2. Before replacing bottom of firebox, route blower power cord through hole in support bracket in bottom of firebox and through hole in side of firebox to grounded,
3. Replace bottom of firebox.
Blower | Electrical |
Outlet | |
| Side Opening |
| Support Bracket Opening |
| Blower Power Cord |
Figure 8 - Routing Blower Accessory Power Cord for
Conventional Installation
NOTICE
A certified electrician must connect electrical wiring to duplex outlet for
1.Install blower assembly per instruction sheet included.
2.Before replacing bottom of firebox, remove screw holding duplex outlet to the support bracket in the bottom of firebox. Remove duplex outlet.
3.Clamp electrical cable into firebox through smallest hole using strain relief provided.
4.Route wires from electrical box through hole in side of heater and hole in support bracket (see Figure 9).
5.Connect wires from the electrical box to duplex outlet. Match wire colors to those indicated on duplex outlet. Be sure to connect ground wire.
6.Replace duplex outlet with screw.
7. Plug blower power cord into duplex outlet.
8. Replace bottom of firebox.
Cables From
Electrical
Source
Duplex Outlet
Blower
Screw
Blower Power Cord
Figure 9 - Routing Blower Accessory Power Cord for Built-In Installation
103296