INSTALLING
Continued
INSTALLING LOG HEATER IN FIREBOX
CAUTION
WARNING ICON | G 001 |
Do not pick up log base assembly by burners. This could damage burners. Only handle base by grates.
1.Remove four screws holding firebox bottom in place.
2.Lift and remove firebox bottom (see Figure 10).
3.If installing GA3500A Blower Accessory (Model FB32C only), see Installing Blower Accessory, page 12.
Figure 10 - Removing Firebox Bottom
4. Route flexible gas line from manual shutoff valve into firebox through side.
NOTICE
Most building codes do not permit concealed gas connections. A flexible gas line is provided to allow accessibility from the firebox. The flexible gas supply line connection to the manual shutoff valve should be accessible.
5.Attach gas log heater base to firebox bottom with four screws included with base (see Installing Heater Base Assembly in log set owner’s manual).
6.Replace firebox bottom and secure with screws.
IMPORTANT: If installing a VL18N/P, VL18NT(A)/PT(A), VL24N/P, VL24NT(A)/PT(A), VS24NV(A)/PV(A), VS18NV/PV, VS24NTA/PTA, VS18NTA/PTA, CF18N/P, CF18NT(A)/PT(A), CF24N/P, CF24NT(A)/PT(A), CFS24NV(A)/PV(A), CF18NV/PV, CF24NTA/PTA, or CF18NTA/PTA gas log heater, locate two mounting brackets included with appliance. Measure these brackets. If overall length is 9 1/4", cut 2" off rear of each bracket with hacksaw (see Figure 11).
Screws
to 
CutLength1/4" 7
Heater Base
Mounting
Bracket
Firebox Bottom
Figure 11 - Cutting Brackets
103296
13