20
CLEANING AND MAINTENANCE SERVICE HINTS TECHNICAL SERVICE WIRING DIAGRAM REPLACEMENT PARTS
CLEANING AND
MAINTENANCE
WARNING: Installation and repair should be done by a qualified service person. The appliance should be inspected before each use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bed- ding material, pet hair, etc. It is imperative that the control compartments, burners, and circulating air sys- tem be kept clean.
TECHNICAL SERVICE
You may have further questions about installation, operation, or troubleshooting. If so, contact DESA’s Technical Service Depart- ment at
You can also visit DESA’s Technical Services web site at www.desatech.com.
WIRING DIAGRAM
PILOT
BURNER
WARNING: The logs can be hot. Handle only when cool.
WARNING: Turn off gas and electrical power before servicing appliance.
IGNITOR
PILOT GAS LINE
THERMOPILE
REPLACE FACTORY WIRING WITH 105¡C EQUIVALENT OR HIGHER RATING
EXTERNAL WIRING USE ONLY CLASS 2 THERMOSTAT WIRE 18 GA. RED/WHITE
|
|
| DO NOT |
|
|
| CONNECT |
| |
RED |
| TO 120V |
| |
|
|
|
| |
WHITE |
|
|
|
|
| N.O. SW | N.C.SW | ||
WARNING: Failure to keep the primary air opening(s) of the burner(s) clean may result in soot- ing and property damage.
PILOT AND BURNER
| ON |
LO | T |
| |
I |
|
P | |
| FF O |
INCOMING
MAIN GAS
SUPPLY
PILOT SAFETY WIRE
TH |
|
|
TP | MANUAL |
|
TH/TP | DAMPER |
|
SWITCH | (VENT SAFETY | |
|
|
SHUTOFF SWITCH)
WALL SWITCH (SUPPLIED)
•Remove logs and ember material before cleaning burner and replace when cleaning is complete.
•Burner and controls should be cleaned with compressed air to remove dust, dirt, or lint.
•Use a vacuum cleaner or small, soft bristled brush to remove excess dust, dirt, or lint.
LOGS
•If you remove logs for cleaning, refer to log placement informa- tion on pages 14 and 15 to properly replace logs.
•Use a vacuum cleaner to remove any carbon buildup on logs.
•Replace log(s) if broken. See Replacement Parts.
•Replace ember material periodically as needed. See Replace- ment Parts.
SERVICE HINTS
When Gas Pressure Is Too Low
•pilot will not stay lit
•burner will have delayed ignition
•fireplace will not produce specified heat
•propane/LP gas supply may be low if using propane/LP gas
If using propane/LP gas, you may feel your gas pressure is too low. If so, contact your local propane/LP gas supplier.
REPLACEMENT PARTS
Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty.
PARTS UNDER WARRANTY
Contact authorized dealers of this product. If they can’t supply original replacement part(s) call DESA’s Technical Service Depart- ment at
When calling DESA, have ready
•your name
•your address
•model and serial numbers of your fireplace
•how fireplace was malfunctioning
•type of gas used (propane/LP or natural gas)
•purchase date
Usually, we will ask you to return the part to the factory.
PARTS NOT UNDER WARRANTY
Contact authorized dealers of this product. If they can’t supply original replacement part(s) call DESA at
When calling DESA, have ready
•model number of your fireplace
•the replacement part number
For more
visit www.
.com
