Optional Weather Enclosure
An optional weather enclosure is available to protect the burner when not in use.
CAUTION: Do not use the weather enclosure if the unit has glass doors installed.
Installation Instructions
1.Turn the unit OFF and allow to cool.
2.Grab the weather enclosure by the handle(s).
3.Slide the top of the weather enclosure up between the back of the surround top and the screen rail. (Fig. 17)
4.Push the bottom of the weather enclosure into the firebox just enough to clear the valve access cover and set down. (Fig. 18)
| Surround Top |
Screen Rail | Weather Enclosure |
|
KT457
Fig. 17 Place top of weather enclosure between surround top and screen rail.
Screen
Hearth Brick
Valve Access Cover
KT458
Fig. 18 Push bottom of weather enclosure into firebox.
ODGSR Series Outdoor Gas Fireplace
Optional Stainless Steel Hood
An optional stainless steel hood is available for both the ODGSR36A and ODGSR42A.
NOTE: The stainless steel hood may NOT be used when the optional glass doors are installed.
Installation Instructions:
1.Turn the unit off and allow to cool.
2.Place the hood so the 2⁵⁄₈" (67 mm) slot clears the sensor plate located under the fireplace opening on the top left side. (Fig. 19)
3.Secure the hood to the unit using the three (3) slots in the hood and the pilot holes in the unit with the stainless steel sheet metal screws provided. (Fig. 19)
4.Align the sides of the hood so the pilot holes on the right and left sides of the unit are exposed through the slots on the ends of the hood. Secure using the remaining stainless steel sheet metal screws. (Fig. 19)
Stainless
Steel Hood
Stainless
Steel Sheet
Metal Screws
(5)
Sensor Plate Slot
FP1635
Fig. 19 Secure stainless steel hood with five (5) sheet metal screws.
20007114 | 11 |