Safety Precautions

IMPORTANT SAFETY INSTRUCTIONS

•Do not operate the cooking center under unprotected combustible construction. Use only in well ventilated areas. Do not use in buildings, garages, sheds, breezeways or other such enclosed areas. This unit is for outdoor use only.

•Do not locate the cooking center where the grill exhaust is directed at combustible materials, windows (open or closed), doorways, etc. The grill vents combustion gases and smoke to the back of the appliance.

•Keep the area surrounding the cooking center free from combustible materials, trash, or combustible fluids and vapors such as gasoline or charcoal lighter fluid. Do not obstruct the flow of combustion and ventilation air.

•Do not use charcoal on the grill.

•Never use the cooking center in a windy area.

•Keep any electrical supply cord, or the rotisserie motor away from the heated areas of the cooking center.

•Never use the cooking center in windy conditions. If located in a consistently windy area (oceanfront, mountaintop, etc.) a wind break will be required. Always adhere to the specified clearances listed in the installation instructions.

•The professional grill is designed for a single layer of lava rock to be spread evenly over the stainless steel radiant tray above the grill burners. To avoid blocking off the area for the grill burners to vent, do not use more than a single layer of lava rock. Adding excess rock can damage ignition components and knobs and void the warranty.

•If a cart unit is stored indoors ensure

that it is cool before attempting to move it. If LP, the cylinder must be unhooked and the LP cylinder stored outside in a well ventilated area, out of the reach of children. From the caster side of the cooking center push, never pull, the cooking center.

•Never use a dented or rusty LP tank. See the requirements in the installation instructions.

•Never put more than one LP cylinder below a cart-mounted cooking center. Never modify the cart to house a larger cylinder or more than one cylinder at a time. Do not store spare tanks in a built-in enclosure.

•Keep the ventilation openings of the LP cylinder enclosure free and clear from debris.

•LP units are supplied with an LP tank equipped with a type 1 connector and an over-fill protection device. If you use a tank exchange system, be sure to exchange this tank for a similarly equipped tank.

SAVE THESE INSTRUCTIONS