Installation, Roughing-in Dimensions | American Standard 6058.105

ADA Compliant

Roughing-in Dimensions

GENERAL DESCRIPTION:

Electronic faucet with proximity operation. Colored LED's signal temperature change mode. Vandal resistant solid brass construction single post mounting. Operates on AC permanent power. Water pressure range from 20 to 80 psi. In-line strainer for solenoid is integral. Single inlet 3/8 compression, built-in checks, and flexible stainless steel 15" reach inlet hose for spout connection.

CODES AND STANDARDS:

These products meet or exceed the following coded standards:

ANSI A117.1 ASME A112.18.1 CSA B 125

183mm (7-3/16)

190mm (7-7/16)

	143mm			132mm
	143mm			(5-3/16)

	(5-5/8)
	(5-5/8)

	55mm D.
	(2-3/16)
	25mm MAX.
	(1)
	381mm
270mm MAX.	(15)
(10-5/8)

	3/8"
175mm MAX.	COMP.
(6-7/8)

114mm (4-1/2)

NSF 61/Section 9

125mm (4-7/8)

1524mm

(60)

81mm

(3-3/16)

3/8" COMP.

3/8"

COMP.

508mm

(20)

TOOLS REQUIRED

1	Channel Locks	5	Flat Blade Screwdriver
2	Adjustable Wrench	6	Electric Drill & 1/4" Drill Bit
3	Plumbers' Putty or	7	Tape Measure
	Caulking

4Phillips Screwdriver

INSTALLATION

1INSTALL SPOUT ASSEMBLY; Fig. 1

		Turn off hot and cold water
	CAUTION	Turn off hot and cold water
	CAUTION	supplies before beginning

1. (Optional) Assemble DECK PLATE (1) and PUTTY

PLATE (2) to FAUCET BODY (3) with SCREW (4). Fig.

2. Insert WIRES (5), FLEX HOSE (6) and SPOUT

SHANK (7) through center hole of mounting surface.

1	2		3
4	5	6	10'	7
Fig. 1		4
		4
		3

Fig. 1a.

3. Assemble "C" WASHER (8) and LOCKNUT (9)

onto threads of SPOUT SHANK (7) from underside of

mounting surface. Fig. 1b.

4. Align FAUCET (3) and tighten LOCKNUT (9). If using

DECK PLATE (1) hand tighten DECK PLATE SPIN

NUTS (10) to secure FAUCET (3) to mounting surface.

Fig. 1b.

Fig. 1a

Fig. 1b	9
	9
7	10

2	M968857 REV. 1. 2