Centro 4000AS warranty Installation, D I T I O N a L R N I N G S

I N S T A L L A T I O N	The installation of this appliance must be in accordance with all local codes, or in the
	absence of local codes:
	• Canadian installation must conform to the current national standards, which at this time
	are CAN / CGA-B149.1/2-Natural Gas / Propane installation code.
	• For natural gas barbecues, contact a certified gas-technician to install your unit.

A D D I T I O N A L

W A R N I N G S

Minimum clearance of 76 cm (30”)

on both sides and back of the barbeque.

Drawing A

Minimum clearance to adjacent combustible materials:

•76 cm (30˝ ) from furthest protruding edge on side of barbecue.

•76 cm (30˝ ) from furthest protruding edge on back of barbecue.

See Drawing A

•Always keep the area around this barbecue clean and clear of any and all combustible materials such as gasoline or other inflammable liquids, paper or oily rags.

•Do not operate this barbecue under any overhanging or unprotected construction.

•Remember this barbecue is for outdoor use only and is not for use on any boat or recreational vehicle.

•Use this barbecue outdoors in a well-ventilated area and at least 3 m (10’) from any dwelling or other building.

•Do not use in garages, or any other enclosed area.

•Do not leave your barbecue unattended while in operation.

•Do not obstruct the flow of combustion and ventilation air to the barbecue.

•Do not use while under the influence of drugs or alcohol.

•Do not store any spare L.P. (propane) cylinders, full or empty, under or near your barbecue.

•Do not allow children or pets to play anywhere near the barbecue.

L . P . G A S C Y L I N D E R	The self-contained (propane) gas system barbecue is designed to be used with only a 9.1 kg
Self-contained	(20 lb) propane cylinder equipped with a type-1 cylinder valve. This barbecue cannot be
	connected to an existing #510 P.O.L. type valve cylinder (which has left-handed threads).
Propane Gas System
	Do not connect to a propane gas cylinder exceeding 9.1 kg capacity or use a cylinder
	with any other type of cylinder valve connection device.
	The Type-1 valve can easily be recognized by the large external thread on the outside of the
	valve. Older existing valves do not have this outer external thread. Any attempt to connect
	a regulator to any connector other than the mating Type-1 connector (which comes with a
	large, black coupling nut such as the #510 P.O.L.) could result in fires, injuries or property
	damage, and could reduce the effectiveness of the important safety features built into the
	Type-1 system. Also connecting the #510 P.O.L. fitting to the cylinder will negate the flow
	control and the temperature shut-off features built into the new Type-1 connection system.
	• The cylinder should not exceed 472 mm (18 1/2˝ ) in height and
	317 mm (12 1/2˝ ) in diameter.

When purchasing a cylinder for your barbecue, it must be constructed and marked as meeting the specifications of:

•Canada: Transport Canada.

LP-gas supply cylinder to be used must be constructed and marked and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339, Cylinders Spheres and Tubes for the Transportation of Dangerous Goods.

1