Centro 3000 T U R a L G a S M O D E L 8 5 1 0 9 9 8 G 5 0 2 1, Parts Included With Your Grill

Page 11

N A T U R A L G A S M O D E L 8 5 - 1 0 9 9 - 8 ( G 5 0 2 1 4 )

Attach the Natural Gas Hose (included with

your barbecue) to the grill. Tighten the female nut of the hose onto the side burner valve using a wrench.

Parts Included With Your Grill

This model comes equipped with a 12’ Natural Gas hose with male socket connection that will allow you to attach your Barbecue to your residential gas line.

W A R N I N G

Do not attempt to use a longer natural gas hose than the one supplied

with your grill, as poor burner performance will be the result.

Before lighting your Barbecue for the first time, and at the beginning of every season you must do the following:

Warning: We strongly recommend contacting a certified gas-technician to install your nat- ural gas grill.

To Connect

1.Push back the sleeve on the socket as shown in figure

2.Insert Plug and release the sleeve as shown in figure

3.Push the plug until the sleeve snaps forward, to lock the plug in the socket.

To Disconnect

1. Push sleeve back and pull the plug out.

Testing For Gas Leaks

Before attempting to operate this Grill:

1.Always confirm that all burner control knobs are in the OFF position.

2.Always connect the gas supply hose first and then open the gas shutoff valve.

3.Always use a brush or spray bottle to apply a 50/50 solution of liquid soap and water to all connection points, to test for gas leaks. Never use a match or open flame for that purpose.

4.Always look for bubbles to appear, as the appearance of bubbles will indicate a gas leak. Always turn off the gas immediately and tighten the connection, if you find that a leak exists.

5.Always repeat this procedure until no further gas leaks are found to exist, before lighting the grill.

6.If a leak cannot be stopped, do not attempt to light the grill.

Always contact Centro Customer Support for assistance. 1-888-707-5463.

Gas Hookup & Warnings

Warnings: Poor Natural Gas Burning Performance and heat distribution is related to the points listed below..

Always consult the Rating Label on the back of the Grill to confirm that it has already been configured to burn natural gas.

All gas supply plumbing must be carried out by a qualified service agency. The Supply con- nection shall be carried out in accordance with provincial authorities having juridiction, and in accordance with CAN/CGA 1-B149.1 & 2 installation code requirements. A shut off valve must be installed between the gas grill and the main supply. For natural gas, use a 3/8” or 1/2” natural gas supply line capable of an input of upto 75,000 BTU’s (depending on the model).

9

Image 11
Contents Serial # BarbecueB L E O F C O N T E N T S E O F L P G a S C Y L I N D E R Installation I N F O R M a T I O ND I T I O N a L R N I N G S L L I N G T H E L P C Y L I N D E R Cylinder must also be equipped withTo Avoid Unnecessary Risks Hose and Regulator Inspection I O R T O U S I N GF E T Y H O S E D R E G U L a T O R Following Must Be Checked To Reset The Gas Regulator Safety DeviceF E T Y A K T E S T I N G Perform a Leak TestR N I N G If the Selected Burner does not Light G H T I N G E G R I L LMatch Lighting The Main Burners Turning The Burners OffShutting Down the Barbecue After Use Lighting the Second BurnerLighting the Side Burner Lighting the Side Burner with a MatchTo Connect Testing For Gas LeaksT U R a L G a S M O D E L 8 5 1 0 9 9 8 G 5 0 2 1 Parts Included With Your GrillR N I N G Page R T S L I S T I N G F O R Item No Quantity Specification1 1 1 4 2 P R O P a N E G 5 0 2 1 1 0 9 9 8 N a T U R a L G a S G 5 0 2 1 1 0 9 9 8 N a T U R a L G a S G 5 0 2 1 Hardware Pack List Tools Needed for AssemblyS E M B L Y I N S T R U C T I O N S Page Page Page Page For propane model only S T R I B U T O R