Centro 3000 warranty G H T I N G E G R I L L, R N I N G If the Selected Burner does not Light

Page 8

L I G H T I N G

T H E G R I L L

Make Sure you have followed all the safety checks, procedures and instructions indicated in the previous section, before attempting to light the grill.

Lighting The Main Burners

1.Always open the hood completely and always inspect the grill and burners to confirm that all components are properly positioned before lighting the main burners.

W A R N I N G

Never stand with your head directly over the Barbecue when preparing

to light the main burners, to prevent possible bodily injury.

2.Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.

3.Slowly turn on the propane gas supply valve at the tank 1-2 turns.

4.Wait approximately 5 seconds before turning the selected burner control to the HIGH position by pushing down on the knob and turning it counter-clockwise. This procedure allows pressure to stabilize, and prevents the flow limiting feature from being activated.

5.Immediately press the Electronic Ignitor. As you press the ignitor you will hear a continuous clicking sound as the module generates an ignition spark to the burner. The selected burner should light within 5 seconds. Light the remaining burners by pushing in and turning the Left and Right control knobs.

W A R N I N G

IF THE SELECTED BURNER DOES NOT LIGHT,

immediately turn the burner control knob and cylinder valve to the OFF

position, to prevent gas buildup. Wait five minutes for the gas to

clear and then repeat the preceding starting procedure. IF the burner will not light when using the Ignitor, follow the match lighting instructions.

6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Barbecue Serial #B L E O F C O N T E N T S E O F L P G a S C Y L I N D E R Installation I N F O R M a T I O ND I T I O N a L R N I N G S L L I N G T H E L P C Y L I N D E R Cylinder must also be equipped withTo Avoid Unnecessary Risks I O R T O U S I N G Hose and Regulator InspectionF E T Y H O S E D R E G U L a T O R To Reset The Gas Regulator Safety Device F E T Y A K T E S T I N GPerform a Leak Test Following Must Be CheckedG H T I N G E G R I L L R N I N G If the Selected Burner does not LightTurning The Burners Off Match Lighting The Main BurnersLighting the Second Burner Lighting the Side BurnerLighting the Side Burner with a Match Shutting Down the Barbecue After UseTesting For Gas Leaks T U R a L G a S M O D E L 8 5 1 0 9 9 8 G 5 0 2 1Parts Included With Your Grill To ConnectR N I N G Page Item No Quantity Specification R T S L I S T I N G F O R1 1 1 4 2 P R O P a N E G 5 0 2 1 1 0 9 9 8 N a T U R a L G a S G 5 0 2 1 1 0 9 9 8 N a T U R a L G a S G 5 0 2 1 Hardware Pack List Tools Needed for AssemblyS E M B L Y I N S T R U C T I O N S Page Page Page Page For propane model only S T R I B U T O R
Top Page Image Contents