Centro 6500 Lighting the Side Burner with a Match, Shutting Down the Barbecue After Use

Page 10

H I

LOW

Lighting the Side Burner

Use the Electronic Igniter on the main control panel and the Side Burner control knob, on the far left panel, to light the side burner.

Push in and turn the side burner control knob to the HIGH position.

Push the igniter button.

If the burner does not light, turn the control knob to the OFF position and wait 5 minutes for the gas to clear.

Repeat the above instructions. If the side burner still does not light,

refer to the troubleshooting section for help or light the burner manually.

Note: The side burner is designed to accept a maximum weight of 20 lb. Do not overload the side burner.

Lighting the Side Burner with a Match

Place match in front ring of provided match holder.

Place a lighted match through the hole to within 16 cm (1/2˝ ) of the side burner.

Push in and turn the burner knob to the “HIGH” position. At this point, the burner should light, if it doesn’t after 5 seconds, turn the

control knob back to the “OFF” position and wait for the gas to clear.

Wait 5 minutes, and then repeat the manual lighting procedure. If after three tries the burner still does not light, review the troubleshooting guide for help.

Shutting Down the Barbecue After Use

Turn off the gas cylinder valve.

Turn the burner control valve to the “OFF” position.

This sequence is important as it prevents residual gas from being left in the system under pressure and will make the next use easier.

Visually Check Burner Flame

Take off the grates and flame tamers. Light burners. Adjust the flame by turning the knobs from “HIGH” to “LOW”. The flames will be smaller when the knobs are in the “LOW” posi- tion. Always check flame prior to each use. Perform flame check for side burner.

8

Image 10
Contents Barbecue Serial #B L E O F C O N T E N T S D I T I O N a L R N I N G S Installation I N F O R M a T I O NE O F L P G a S C Y L I N D E R To Avoid Unnecessary Risks Cylinder must also be equipped withL L I N G T H E L P C Y L I N D E R I O R T O U S I N G Hose and Regulator InspectionF E T Y H O S E D R E G U L a T O R Perform a Leak Test To Reset The Gas Regulator Safety Device F E T Y A K T E S T I N G Following Must Be CheckedG H T I N G E G R I L L R N I N G If the Selected Burner does not LightTurning The Burners Off Match Lighting The Main BurnersShutting Down the Barbecue After Use Lighting the Side BurnerLighting the Side Burner with a Match Visually Check Burner FlameA R Z O N E O P E R a T I N G S T R U C T I O N S Balancing the Food P S O N U S I N G U R R O T I S S E R I EGuide to Rotisserie Cooking Food PreparationParts Included With Your Grill Testing For Gas LeaksT U R a L G a S M O D E L 8 5 1 6 1 7 6 G 6 1 0 0 To ConnectR N I N G Page Item No Quantity Specification R T S L I S T I N G F O R1 6 1 6 8 P R O P a N E G 6 1 0 0 1 6 1 7 6 N a T U R a L G a S G 6 1 0 0 1 6 1 7 6 N a T U R a L G a S G 6 1 0 0 S E M B L Y I N S T R U C T I O N S Tools Needed for AssemblyHardware Pack List For propane model only Page Page Page 14.1 14.2 14.4 Moonlights and Grilling System operate independently14.5 Page Replacing Light batteries Batteries are not includedS T R I B U T O R