Centro 6500 warranty Turning The Burners Off, Match Lighting The Main Burners

Page 9

Drawing G

6.Confirm that the burner is properly lit. If the flame pattern is other than normal, consult the Troubleshooting Guide for corrective action.

7.Always preheat the Barbecue before starting to cook. Light all burners and adjust them to the HIGH position for 5-10 minutes. Before placing any food on the Barbecue, clean the cooking grids with a Porcelain cleaning brush.

8.Adjust the controls to a medium setting for most cooking requirements. A light coating of cooking oil on the cooking grids, before heating the grill, will prevent foods from sticking to the grill.

Turning The Burners Off

1.Always turn the burner control knobs to the off position when cooking has been completed.

2.Promptly turn OFF the gas supply valve at the propane cylinder.

3.Close the hood of the grill.

Match Lighting The Main Burners

1.Always open the hood completely and inspect the grill and burners to confirm that all components are properly positioned, before lighting the main burners.

W A R N I N G

Never stand with your head directly over the Barbecue when preparing

to light the main burners, to prevent possible bodily injury.

2.Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.

3.Always turn on the propane gas supply valve at the tank (1-2 turns).

4.Insert a lit match or a butane lighter into the match lighting hole located on the lower left hand side of the firebox (Drawing G).

5.Turn the left burner control knob to the HIGH position by pushing on the knob and turning it counter-clockwise.

W A R N I N G

If the heat output is too low, the flow control feature may have been activated by a gas leak. If so, turn off the burner valve and cylinder valve, and perform the “Leak Test”. If there aren’t any leaks, re-light the burner.

7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Serial # BarbecueB L E O F C O N T E N T S Installation I N F O R M a T I O N D I T I O N a L R N I N G SE O F L P G a S C Y L I N D E R Cylinder must also be equipped with To Avoid Unnecessary RisksL L I N G T H E L P C Y L I N D E R Hose and Regulator Inspection I O R T O U S I N G F E T Y H O S E D R E G U L a T O R F E T Y A K T E S T I N G To Reset The Gas Regulator Safety DevicePerform a Leak Test Following Must Be CheckedR N I N G If the Selected Burner does not Light G H T I N G E G R I L LMatch Lighting The Main Burners Turning The Burners OffLighting the Side Burner with a Match Lighting the Side BurnerShutting Down the Barbecue After Use Visually Check Burner FlameA R Z O N E O P E R a T I N G S T R U C T I O N S Guide to Rotisserie Cooking P S O N U S I N G U R R O T I S S E R I EBalancing the Food Food PreparationT U R a L G a S M O D E L 8 5 1 6 1 7 6 G 6 1 0 0 Testing For Gas LeaksParts Included With Your Grill To ConnectR N I N G Page R T S L I S T I N G F O R Item No Quantity Specification1 6 1 6 8 P R O P a N E G 6 1 0 0 1 6 1 7 6 N a T U R a L G a S G 6 1 0 0 1 6 1 7 6 N a T U R a L G a S G 6 1 0 0 Tools Needed for Assembly S E M B L Y I N S T R U C T I O N SHardware Pack List For propane model only Page Page Page 14.1 14.2 Moonlights and Grilling System operate independently 14.414.5 Page Batteries are not included Replacing Light batteriesS T R I B U T O R
Top Page Image Contents