4. Side Burner Valve Assembly
(a)Remove side burner grate from side burner shelf and set aside. Remove the two Phillips head screws attaching side burner (N) to shelf to make room to install side burner valve. See (Fig.12)
(b)Remove two screws from side burner control valve face. Insert side burner valve control stem through hole in side burner control panel . Place side burner control knob bezel (T) over side burner valve control stem.
Secure bezel to control panel and valve with 2 screws removed above. (Fig . 13A1).
(c)Insert side burner tube over side burner valve orifice (Fig. 13B1). Use the two previously removed side burner screws to reattach side burner to side burner shelf.
(d)Push control knob (U) onto valve control stem, and tighten use hex wrench. (Fig.14)
(e)Plug ignition wire into igniter wire hanging from electrode on underside of burner (Fig.15).
(f)Replace the side burner grate into the side burner shelf.
Fig. 12 |
N |
Fig. 13 |
|
| B1 |
T | A1 |
|
Fig. 14 |
U |
Fig. 15 |
13