
Match Lighting
sDo not lean over grill while lighting.
1.Open lid. Turn gas on at LP tank.
2.Place lit
3.Push in and turn control knob to HIGH. Be sure burner lights and stays lit.
CAUTION |
General Grill Cleaning
•Clean porcelain grill lid and bottom with soap and water or
•Replace ceramic briquets as frequently as necessary to avoid grease buildup and
•Porcelain grate: Because of
•Clean burner twice a month when in regular use. Clean burner prior to use after storage. Spiders and insects like to build nests in burner tubes (especially during colder months). These nests can cause flashback (fire in burner tube).
Repainting Your Grill
•After extended use and exposure to weather, paint on grill legs may deteriorate or become spotted. Although this detracts from grill’s appearance, it will not impair its performance.
•To refinish grill legs, use wire brush and lightly sand with fine grit sandpaper. Sanding allows new paint to adhere more easily. Refinish legs with heat resistant paint.
Storing Your Grill
|
| • Clean cooking grate and discard old briquets. |
|
| • Apply a light coating of vegetable oil to heat plate. |
| Typical spider web inside burner | • Store in dry location. |
| • When LP tank is connected to grill. Store both outdoors in | |
|
| |
|
| wee ventilated space and ut of reach of children. |
|
| • Cover grill if stored outdoors. Choose from a variety of grill |
|
| covers offered by the manufacturer. |
Cleaning the Gas Train | • Store grill indoors ONLY if LP tank is disconnected, removed | |
from grill and stored outdoors. | ||
1. | Turn gas OFF at knob and LP tank. |
|
2. | Remove cooking grate and grease cup (A). | A |
3. | Remove acorn nuts and burner plate (B). | |
4. | Disconnect ignitor wire from electrode. Wipe ceramic portion |
|
5. | of electrode with rubbing alcohol and cloth (C). |
|
Examine upper and lower surfaces of burner tube closely (D). |
| |
| If any cracks or holes are found, replace burner tube. |
|
Valve
sVERY IMPORTANT:
When replacing burner tube, burner tube must pass through hole in valve cover and engage valve attached to control leg.
Burner Tube
6.Using garden hose (preferably with nozzle), force water
B
7. | through burner tube to clean. | C |
Replace burner place and acorn nuts. |
| |
8. | If grill is to be stored, coat tube burner lightly with cooking oil. |
|
9. | Wrap protective cover over each end to keep insects out. |
|
Attach flat end of ignitor wire to electrode. |
| |
10. | Add briquets to grill. |
|
11. | Replace cooking grate and grease cup. | D |
12. | Before cooking again on grill, follow Gas Flow Check. | |
13. | Grill must be completely dry before cooking. | A |
06601295 • 7