For your safety
Care and Cleaning
Beverage Center
Unplug the beverage center before cleaning. If the unit is in a
Cleaning the outside
The exterior surfaces can be washed with mild soap and water. Rinse thoroughly with clear water. Never use abrasive scouring powders.
Do not use scouring pads, powdered cleaners, bleach or cleaners containing bleach because these products can scratch and damage the finish.
Warranty does not cover damage due to improper cleaning methods.
Glass door
Door gasket
Use a glass cleaner or mild soap and water and a soft cloth to clean the glass door. Do not use any abrasive powders.
The vinyl gasket may be cleaned with mild | After cleaning the door gasket, apply a thin |
soap and water, a baking soda solution or | layer of paraffin wax or petroleum jelly to |
a mild scouring powder. Rinse well. | the door gasket at the hinge side. This helps |
| keep the gasket from sticking and bending |
| out of shape. |
Light bulb replacement
Unplug the beverage center before replacing the light bulb. If the unit is in a
To remove the light shield, push in the tab on the left side of the shield and lower it. Replace with a 15 watt appliance bulb.
In the event of a power failure
Preparing to move
If the power fails, open the door as | Do not store or use gasoline or other |
infrequently as possible to maintain | flammable vapors and liquids in the |
the temperature. | vicinity of this or any other appliance. |
Secure all loose items such as shelves and | Be sure the beverage center stays in an |
drawers by taping them securely in place to | upright position during moving. |
prevent damage. |
|
11
