10
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.
1/4-20x1½”
7mm flat 7mm lock screw washer washer
11 First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two
Screws and Washers removed from valve bracket
Note: Use left and right holes on fascia to attach valve bracket
Install bezel with “OFF” at top.
Note: Use upper and lower
holes on fascia to
attach bezel
Control knob |
4mm
lock washer
Sideburner
fasciaControl knob bezel
Sideburner valve bracket
Valve stem
20