Care, Maintenance and Cleaning (continued)
Replacing the Electrode Module
Steps For Replacing the Electrode Module:
1.Remove the cooking grates and the heat tents and set aside.
2.Using a 1/4” hex nut driver, remove the
3.The electrode module is now visible. Remove the four wires that are factory installed from the electrode module to the burner electrodes (Fig. 51).
4.To remove the electrode module, unscrew the igniter button and remove the AA battery. Next, unscrew the plastic hex nut from the electrode module (Fig. 52).
5.Reverse the procedure to install a new electrode module.
NOTE: It does not matter which ignition wire goes to which tab on the electrode module.
24
Fig. 49
Fig. 50
Fig. 51
Electrode |
|
Module | Wires |
Fig. 52