Coleman 5600 manual 25-A, 25-B, 25-C, 25-D

	Ö	Assemble the Motor Mount
		Bracket to the right outside of
Step		the Firebox.
	Ö	Assemble the Rotisserie to
25		the Firebox.

Hardware shown actual size

(TN)	(UO)
M6 x 15mm Screw	M6 Locking Hex Nut
(2) Qty.	(2) Qty.

25-A

UO (x2)

TN (x2)

Motor Mount Bracket

25-A. Attach the Motor Mount Bracket to the metal side panel using two Screws (TN) and two Hex Nuts (UO).

25-B

Motor

25-B. Slide the Motor onto the Motor Mount Bracket.

25-C	NOTE:
Slip Collar
	Machined
	Groove
Fork	Toward
	Handle
	Spit Rod
Handle
Set Collar
	Fork
Pointed Tip

25-C. Loosely assemble the Rotisserie parts as shown in Figure 25-C. Do not tighten the thumbscrews until prop- erly positioned in step 25-D.

25-D
	Set Collar
Small Gap here
Firebox
Wall	Slip Collar

25-D. Insert Pointed Tip of the Spit Rod into the Motor.

ÖPlace Slip Collar on Firebox Wall. Make sure the pointed tip of the Spit Rod stays in the Motor.

ÖPush Set Collar against the Slip Collar, provide a small gap to allow the Spit Rod to freely turn.

ÖTighten the thumbscrews on the Set Collar and the Forks to hold in place.

28