Hold coupling nut and regulator as shown for proper connection to LP tank valve.
Leak Testing Valves, Hose and Regulator
1.Turnall grill control knobsto OFF.
2.Be sure regulator is tightly connected to LPtank.
3.Compieteiy open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major Ieak at the connection. Correct
before proceeding by calling Sears for replacement parts at
4.Brush soapy solution onto areas where bubbles are shown in picture below:
Never remove threaded orifice at end of valve.
6.Turn the coupling nut clockwise and tighten to a fuII stop. The regulator wilI seat on the
NOTE"
If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to complete the connection, do not use this regulator!
Catt
•Do not insert any tool or foreign object into the valve outlet or safety relief valve. You may damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.
•Outdoor gas appliance is not intended to be installed in or on a boat.
•Outdoor gas appliance is not intended to be installed in or on an RV.
•Never attempt to attach this grill to the
•Do not use grill until
•If a leak is detected at any time, STOP and call the fire department.
•If you cannot stop a gas leak, immediately close
LP cylinder valve and call LP gas supplier or your fire
department!
5.If "growing" bubbles appear, there is a leak. Close LPtank
valve immediately and retighten connections. If leaks cannot be stopped do not try to repair. CatI Sears for replacement
parts at
6.Aiways ciose LPtank valve after performing teak test by
turning hand wheel clockwise.
6 °