_! Ignitor Battery Installation
1.Remove the Ignitor Cap located on the grill Control Panel.
2.Place the manufacturer supplied AA battery into the Ignitor Slot. Be sure to place the positive pole facing toward you.
3.Place the Cap and Spring over the AA battery then tighten the Ignitor Cap onto the grill Control Panel.
4.Remove any protective film from outside and inside of Grill Head.
AABATTERY
IGNITOR _'_"
SPRING
IGNITOR
SLOT
_'_ Electrode Check - Requires an
Assistant
Before placing the cooking components into your grill, ensure that the Spark Electrode Tip is propedy positioned within each Gas Collector Box (a
1.Be sure all Control Knobs are set to "OFF" and open the Grill Lid.
2.Have an assistant stand behind to the right of the grill and look down at each Gas Collector Box. NEVER put your face inside Grill Head.
3.Press the Ignitor Cap. You should hear a "clicking" sound and your assistant should see a small blue spark within each Gas Collector Box. If a spark is present the Electrode Tips are properly positioned.
4.If no spark is seen, the Spark Gap, as shown below, needs to be adjusted as follows:
Using an adjustable wrench, loosen the Inside Nut just until the Gas Collector Box can be maneuvered and turned upward.
The gap between the Spark Electrode Tip and Spark receiver should be approximately 3/16".
If the gap is wider than 3/16" use a pair of long nose pliers and gently squeeze the Gas Collector Box until the gap is correct.
Return the Gas Collector Box to its odginal hodzontal position, secure the Inside Nut and try
the Electrode Check again.
. If no "clicking" sound is heard check the following common causes. If you need assistance call the Grill Information Center at
•Ignitor AA battery not installed propedy.
Electric wires may be loose. Remove the AA battery, inspect the Ignitor Junction Box found behind the Control Panel, and connect any loose wires.
GAS COLLECTOR BOX
INSIDE NUT
SPARK RECEIVER
15