SPIDER ALERT!
IMPORTANT: Always ensure that the venturi burner tubes are clean. A venturi burner tube has a narrow area in which spiders tend to build nests.
If you notice that your grill is getting hard to light or that the flame isn'tas strong as it should be, take the time to check and clean the venturi's.
Spiders or small insects have been known to create "flashback" problems. The spiders spin webs, build nests and lay eggs in the grill's venturi tube (s) obstructing the flow of gas to the burner. The
To prevent flashbacks and ensure good performance the burner and venturi assembly should be removed from the grill and cleaned •before use whenever the grill has been idle for an extended period.
Storing Your Grill
•Clean cooking grates.
•Store in dry location.
•When LPcylinder is connected to grill, store outdoors in a
•Cover grill if stored outdoors. Choose from a variety of grill covers offered by manufacturer once available.
•Store grill indoors ONLY if LP cylinder is turned off and Disconnected, remove from grill and stored outdoors.
•When removing grill from storage, follow "Cleaning the Burner
Assembly' instructions before starting grill.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembiy or if you have froubie igniting griii.
1.Turn gas off at control knobs and LPcylinder
2.Remove cooking grates and heat diffusers.
3.Remove screws and carryover tubes from rear of burners.
4.Remove screw and washers to disengage burner from
b.rackef on firebox.
5.Remove screws fo detach electrode from burner. Electrode should remain in firebox.
6.Carefully tift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A)Bend a stiff wire (a light weight coat hanger works well) into a small hook. Runthe hook through each burner tube several times.
(B)Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each burner tube several times.
(C)Wear eye protection: Use an air hose to force air into the burner tube and out the burner ports. Check each port to make sure air comes out each hole.
7.Wire brush entire outer surface of burner to remove food residue and dirt.
8.Clean any blocked ports with a stiff wire such as an open paper clip.
9.Check burner for damage, due to normal wear and corrosion some holes may become enlarged. If any large cracks or holes are found replace burner.
VERY IMPORTANT: Burner tubes must reengage valve
openings. | See illustrations at right. | Correct | ||
10. | Attach | electrode | to burner. | |
11. | Carefully replace | burners, | engagement | |
12.Attach burners to brackets on firebox.
13.Reposifion carryover tubes and attach to burners. Replace flame tamers and cooking grates.
16153- 50300312 ° 9