Rotate
Cylinder
Cylinder
Retainer Clip
FIG. 11A
4)Cut the tie clamp securing the regulator and Hose to the burner tube.
|
|
|
|
|
|
|
| Cut regulator Hose |
|
|
|
| Tie Clamp |
|
| FIG. 11B |
| ||
|
|
|
| |
|
|
|
|
|
5)Remove the protective cap from the LP cylinder nozzle. (Save cap for
Hand tighten coupling
nut in clockwise direction
Remove
Protective Cap
FIG. 11C
To avoid pinching in next step, keep fingers and hands near corners of Cylinder Retainer Clip when swinging Clip over cylinder.
6)Swing the Cylinder Retainer Clip over round shoulder of the LP cylinder. Exert pressure at ends of clip until it stops at the cylinder carry handle.
Cylinder
Carry Handle
Cylinder
Retainer Clip
FIG. 11D
Disconnecting LP gas cylinder:
1)Turn all control knobs to the “off” position and turn the handle on the LP gas cylinder clockwise until it stops.
2)Turn coupling nut on regulator counter- clockwise until regulator is released from the threaded LP cylinder gas nozzle.
3)Replace the protective cap over LP cylinder gas nozzle.
BEFORE USING YOUR GAS GRILL
INSTALLATION CODES
To reduce the risk of serious bodily injury or death:
·This installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54 Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2 or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA 1192 and CSA Z240 RV Series, recreational Vehicle Code, as applicable.
·If an external electrical source is utilized, the outdoor cooking appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Codes, ANSI/NFPA 70, or the Canadian Electrical Code CSA C22.1.
·Keep any electrical supply cord away from any heated surfaces.
13