Assemble Hood/Bowl to Cart | Aussie 7110 specs

Step 3) Assemble Hood/Bowl to Cart:

(15) BOLT, M6X45

4 PC

(14) HOOD/BOWL ASSEMBLY

NOTE: REQUIRES 2-PERSONS

·With Cart upright, align Bowl Bracket legs with Cart legs. (FIG. 3A)

·Lower Hood/Bowl so ends of Cart legs insert into Bowl Bracket legs.

·Press downward until leg screw holes align. NOTE: If cart legs do not align and fit into Bowl Bracket legs easily, loosen the Control Panel bolts slightly. Then open the Hood and loosen the 2-Bowl/Leg bolts on either, or both sides of the Bowl. (FIG. 3B)

·Insert M6x45 Bolts from the outside through the legs and tighten with M6 Locknuts. (FIG. 3C)

·Re-tighten all Bolts.

View Inside Bowl

Bowl/Leg Bolts

Left and Right

Sides

FIG. 3B

(16) M6 LOCKNUT

4 PC

Bowl Bracket Legs

Control Panel Bolt on each side of grill

FIG. 3A

(15) M6 Nut

(16) BOLT, M6X45

FIG. 3C

Step 4) Install Drip Cup:

Insert Drip Cup into Drip Cup Holder ring until the cup flange is flush with the ring and the notch in the lip of the cup fits the vertical hanger wire.

Align groove with vertical wire

(17) DRIP CUP