7
Before Using Your LP Gas Grill
Installation Codes
!WARNING
To reduce the risk of serious bodily injury or death from fire or explosion:
•This installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54 Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2 or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA 1192 and CSA Z240 RV Series, Recreational Vehicle Code, as applicable.
•If an external electrical source is utilized, the outdoor cooking appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Codes, ANSI/NFPA 70, or the Canadian Electrical Code CSA C22.1.
•Keep any electrical supply cord and the fuel supply hose away from any heated surfaces.
Selecting a Location
!WARNING
To reduce the risk of serious bodily injury or death from fire or explosion:
•Use this outdoor cooking appliance only outdoors and never in a building, garage, breezeway, carport, porch or in any enclosed area. Locate outdoor cooking appliance in an area with good ventilation on a level stable surface clear of combustible and flammable material.
•Locate your LP gas grill at least 10 feet away from your house or any building.
•Maintain minimum clearances of 36” from back and sides of grill to any combustible construction.
•Do not locate this appliance under overhead, unprotected combustible construction.
•This outdoor cooking appliance is not intended to be used in/on boats or installed in/on recreational vehicles.
•Never use gas grill as a space heater.
Before using your gas grill, perform a leak test on the
Regulator Connection and LP Gas Cylinder. (See page 6 of this Manual)
Lighting the Grill
!WARNING
To reduce the risk of serious bodily injury or death from fire or explosion:
•Open Hood before lighting the grill to release trapped gas.
•Light each burner from the left before lighting the next burner to prevent gas from accumulating.
•During failed lighting attempts, or if the Burners go out during operation, turn Control Knobs “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.