Aussie 6703C8FKK1 manual Lighting the Grill Using the Pulse-Spark Ignitor, Off position

18

Lighting the Grill Using the Pulse-Spark Ignitor

!WARNING

To reduce the risk of death or serious injury from an explosion or a fire beneath the grill:

•Inspect and clean Burner/Venturi Tubes for insects or insect nests. Spiders or small insects can build nests, webs, and lay eggs in the grill’s Venturi Tubes, (Fig 15, page 27) obstructing the flow of gas to the Burner. The backed-up gas can ignite behind the Control Panel and cause a fire beneath the grill, posing the risk of death or serious bodily injury. This is known as a “flashback.”

•Be sure Burners are re-installed properly before using grill.

Should you notice that your Burner(s) are getting hard to light or the flame is not as hot as it once was, refer to the “How to Clean your Burners” section on page 27, to remove any possible obstructions.

!WARNING

To reduce the risk of serious bodily injury or death from fire or explosion:

•Open Hood before lighting the grill to prevent an explosion from gas build-up.

•During failed lighting attempts, or if the Burners go out during operation, turn Control Knobs “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.

•Light each burner from the left before lighting the next burning to prevent gas from accumulating.

1.Open the Hood.

2.IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 7)

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)

Control Knob in	Control Knob in High
	position (large flame
Off position	symbol)
		Turn LP Gas
	Fig. 8	Cylinder valve
		counterclockwise
Fig. 7

Left Main Burner

Control Knob

Fig. 9

Igniter Button

Right Main Burner Control Knob

4.Push far left Main Burner Control Knob in on Control Panel and turn counterclockwise to the High position. (Figs. 7 and 9)