Broilmaster BDA-1, BSA-1, BRB-1, BHA-1, BHAX-1, BBA-1 Alternate Match Lighting Instructions

BHA & BHAX Assembly

10.Install each of the four vent covers (BRB Vent Register Kit) into the Built-In Kit Enclosure using two #8 x 3/4” screws. See Figure 9.

Figure 9

Alternate Match Lighting Instructions

1.Turn the burner control knobs clockwise to the OFF position.

2.Turn ON gas at the source.

3.Open the grill lid.

4.Open the BHA access door. Locate the Ignitor Rod, which is permanently attached to the inside of the Bottom Shelf.

5.Insert an unlit match into the coiled end of the ignitor rod. Light the match.

6.Insert the ignitor rod inside the access door and through the front left air hole located on the bottom of the grill. Position the match near the rear left corner of the burner.

See Figure 10.

7.Turn the left burner control knob counterclockwise to HI.

8.If the burner fails to light after 5 seconds, turn the burner control knob OFF for five minutes then repeat the procedure.

9.If the burner continues not to light, turn OFF all gas and refer to the troubleshooting section of your grill Owner’s

Manual.