BDA DOUBLE DOOR INSTALLATION
NOTE: You will need two BDA door kits for this installation.
1
Remove doors from frames by depressing one of the spring loaded pins on each door and set them aside. Disassemble frame by removing the two screws and door pin from both door frames as shown in FIGURE 5.
3
Make sure BDA Double Door opening dimensions match those in FIGURE 7. Place the Frame into the opening and check for proper hole alignment. Secure the Frame to the enclosure with 2 screws. FIGURE 7.
Secure the Doors to the door frame by inserting the spring loaded pins in the bottom frame holes. Locate the upper hole in the BDA frame and push on the spring loaded pin on the door and insert it into the frame.
Figure 4.
Make sure the Door is Aligned and Secured prop- erly by opening and closing door.
27 ½”
19 13/16”
FIGURE 5
2
Use the door brackets included in the hardware packages to combine the frames. Use the screws from the single door to attach the bracket, and place the door pin in position. FIGURE 6
FIGURE 7
FIGURE 6
Page 21 |