Checking for Gas Leaks, Using Matches | Broilmaster T3N-1 T3C-1

OPERATION - PROPANE & NATURAL GAS GRILLS

Checking for Gas Leaks

Check for gas leaks every time you connect your Broilmaster propane gas grill to a Propane gas cylinder, when a connected cylinder has not been used recently, or when either a natural or propane grill is being used for the ﬁrst time.

Caution: Do not use an open ﬂame when checking for leaks. Checking for leaks with an open ﬂame may lead to a ﬁre or explosion, resulting in property damage or personal injury.

To check for gas leaks:

1.Use dish washing liquid and a little water to make a soapy solution.

2.Turn OFF the knob on the control panel.

3.Turn ON the gas at the supply or cylinder. A hissing sound indicates a leak. Turn OFF the gas and repair the leak.

4.Apply the soapy water solution to all gas connections.

5.Look for bubbles. Bubbles indicate a leak.

6.If there are bubbles turn OFF the gas and repair the leak.

7.Turn the gas back ON and repeat the above procedures until all leaks are repaired.

Air Shutter Adjustment

The burner (venturi) tube air shutter is preset at the factory so that after ﬁve minutes the burner ﬂames are blue with well deﬁned cones. If, after ﬁve minutes the ﬂame is yellow, or there is a gap between the burner and the ﬂame, adjust the burner (venturi) tube air shutter as follows:

1.Turn gas OFF and let the burner cool.

2.Beneath the control panel you can access the air shutter(s) which are located on the end of the burner tubes.

3.Loosen shutter set screw

4.Close the air shutter to the minimum opening.

5.Light the burner, wait ﬁve minutes and then carefully open the air shutter until the ﬂame is blue and well deﬁned.

6.Retighten the set screw.

Operating Instructions

Before each use, inspect all hoses. If it is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to using your Broilmaster grill. Call your local Broilmaster dealer for a replacement.

Using the Ignitor

Caution: If a burner fails to light after 5 seconds, turn the burner OFF for 5 minutes, to allow the gas to clear, then try again.

Note: Each burner must be lit individually.

1.Turn knob on the grill CLOCKWISE to the OFF posi- tion.

2.Turn ON gas at the source.

3.With the grill lid open, push and turn the burner control knob COUNTERCLOCKWISE to Hi.

4.Push and hold the ignitor button until the burner lights (approximately 5 seconds).

5.If a burner does not light, turn OFF all gas and refer to the Troubleshooting section of this manual.

6.Repeat steps 3 through 5 for other burner.

Using Matches

Caution: If a burner fails to light after 5 seconds, turn the burner OFF for 5 minutes, to allow the gas to clear, then try again.

Note: Each burner must be lit individually.

1.Turn knob on the grill CLOCKWISE to the OFF posi- tion.

2.Turn ON gas at the source.

3.Open the grill lid.

4.Insert a burning long wooden match through the lighter hole on either side of the grill. See Figure 21.

5.Turn the burner control knob COUNTERCLOCKWISE to HI.

6.If a burner does not light, turn OFF all gas and refer to the Troubleshooting section of this manual.

7.Repeat steps 3 through 6 for other burner.

Figure 21

Page 18

B101051-0-1106

T3-1, T3CFN-1, T3CN-1 T3CF-1, T3N-1 T3C-1 specifications

The Broilmaster T3 series comprises a lineup of high-quality grills designed for outdoor enthusiasts who crave grilling excellence. This series includes models such as the T3CFN-1, T3CN-1, T3CF-1, T3-1, T3N-1, and T3C-1, which share a range of innovative features and technologies that set them apart in the grilling market.

One of the standout features of the Broilmaster T3 grills is their construction. Built with heavy-duty cast aluminum, these grills balance lightweight design with robust durability, meaning they can withstand the elements while providing consistent performance. The powder-coated finish not only enhances the grill’s aesthetic appeal but also offers a layer of protection against rust and corrosion.

Broilmaster T3 models are equipped with the patented “Dual-Heat System” that allows for versatile cooking options. Users can toggle between direct and indirect heat, making it easy to sear meats or cook larger cuts more slowly. The solid stainless-steel burners provide efficient and even heat distribution, ensuring that every meal is cooked to perfection.

In terms of technology, the T3 series incorporates an advanced ignition system that allows for quick starts, paired with the stainless-steel cooking grids that enhance heat retention and flavor. The grilling surface is spacious enough to accommodate large meals, making these grills ideal for gatherings and family events.

One of the most appreciated characteristics of the Broilmaster T3 series is its user-friendly design. The grill features an easy-to-read temperature gauge, side shelves for additional preparation space, and a convenient grease management system that simplifies cleanup. Additionally, the optional accessories, such as rotisserie kits and smoker boxes, enable users to expand their culinary horizons.

The Broilmaster T3CFN-1, T3CN-1, T3CF-1, T3-1, T3N-1, and T3C-1 share an overall commitment to quality, performance, and innovation. With their sturdy build, versatile cooking options, and thoughtful design, these grills cater to both novice and experienced grillers alike, ensuring that every outdoor cooking experience is a memorable one. Whether you’re grilling burgers for a weekend cookout or slow-roasting a brisket for a special occasion, the Broilmaster T3 series stands ready to deliver exceptional results every time.