GRILL ASSEMBLY
Install the Burner
1.Insert the burner assembly into the grill bottom with the venturi tubes facing the front of the grill. See Figure 12.
2.Carefully slide the wires through the same hole in the bottom of the grill.
5.Slide the bridge pin through the hole in the
Figure 12
3.Slide the venturi on to the valve assembly.
4.Raise the unsecured end of the burner bracket and slip it over the
Figure 13
Figure 14
Connect Igniter Wires and Install Battery
1.Attach ground and igniter wires to the igniter as shown in Figure 15.
2.Remove push button cap and insert AA battery, positive side down, as shown in Figure 15.
Figure 15
Page 16 |