3Com X3 owner manual Anti Car-Jacking Manual Activation, Anti Car-Jacking Automatic Activation

Page 12

K. Anti Car-Jacking (Manual Activation)

Warning: If you don’t need this alarm system’s car-jacking function to be “On”, set it to “Off”. The default car-jacking setting is “Off” (see Feature No. 6 on programming chart).

Pressing and holding the “Lock” and “Unlock” button on the transmitter for 1 second while the vehicle’s ignition is “On” will trigger the car-jacking. The parking lights will turn on for 1.5 seconds to indicate car- jacking is activated.

1.60 seconds after the system has been triggered, the siren starts alarming and the parking lights start flashing.

2.90 seconds after the system has been triggered.

A.The siren will still be sounding and the parking light flashing and,

B.The starter disable will activate to prevent the vehicle from being restarted,

C.It will remain active until the vehicle’s battery power is exhausted.

L. Anti Car-Jacking (Automatic Activation)

Warning 1: If you don’t need this alarm system’s car-jacking function to be “On”, set it to “Off”. The default car-jacking setting is “Off” (see Feature No. 6 on programming chart).

Warning 2: When this feature is programmed for “Automatic Mode” operation, the car-jacking feature is armed at all times when the ignition key is on. Opening any protected entrance while the vehicle’s ignition is “On” will trigger the car-jacking system.. The parking lights will turn on for 1.5 seconds to indicate car- jacking is activated.

1.60 seconds after the system has been triggered, the siren starts alarming and the parking lights start flashing.

2.90 seconds after the system has been triggered.

A.The siren will still be sounding and the parking light flashing and,

B.The starter disable will activate to prevent the vehicle from being restarted,

C.It will remain active until the vehicle’s battery power is exhausted.

Override the System to Turn Off Car-Jacking:

Turn the ignition switch from “Off” to “On”, and within 10 seconds push valet switch, the siren will stop and the system will disarm.

© Copyright 2008-2009 Magnadyne Corporation

X3-IMUM 7-24-08 Rev. A

Image 12
Contents Installation Owner’s Manual For Technical Assistance, please call 800Table of Contents Component InstallationWiring HC4 White 12-Pin Main HarnessWiring Harness Quick Reference Violet Wire + Common Door Pin InputOrange Wire Ground when Armed Output HC4 12-Pin Main HarnessBlack Wire Chassis Ground Brown Wire Siren OutputWhite/Red Wire +/- Parking Light Relay Input Red Wire +12VDC Battery InputOptional Wiring Diagrams HC3 Black 3-Pin Door Lock HarnessBrown Wire When programmed for Horn Output Programming the TransmitterAlarm Feature Programming 3X3X5X + 1X Hold Turn On the IgnitionShock Sensor Testing and Adjustment Transmitter Operation Alarm Status IndicatorsDual-Zone Shock Sensor Manual Arming LockAutomatic Arming Valet Mode Enter Valet ModeExit Valet Mode Manual Disarming UnlockAnti Car-Jacking Manual Activation Anti Car-Jacking Automatic ActivationOverride the System to Turn Off Car-Jacking